Troubleshooting - Vuescape iPod Docking AM/FM Stereo Clock Radiowith Alarm Installation And User Manual

Troubleshooting

PROBLEM
No sound •
The volume is set too low.
•
Headphones (or earbuds) are
plugged into the unit.
•
The iPod is not inserted properly.
•
The iPod is paused or in the Hold
position.
•
The iPod may need to be reset.
Distorted •
The volume level is too high.
sound
•
The song file is distorted.
Unit warm •
This is acceptable, especially if
after lengthy
the volume is at a high level.
play.
No power •
The Insert is not securely
connected.
•
The electrical outlet is not
operational.
No power - •
The transmitter on the front of the
Remote
Remote or the sensor on the front
Control
of the unit is blocked.
•
The battery power is low.
•
The batteries are incorrectly
installed in the Battery
Compartment.
iPod did not •
The iPod is not seated properly in
charge
the Dock.
•
The iPod is not operating properly.
Can't access
the files on
my 5GB iPod
(with Video)
or iPod nano
Note: Please make sure that your iPod has the latest firmware. Check your iPod manual or the
Apple website (www.apple.com) and follow the instructions on how to upgrade the firmware of
your iPod.
PROBABLE CAUSE RESOLUTION
•
Increase the volume by pressing the VOL+ side of
the Volume Button.
•
Unplug the headphone (or earbuds).
•
Remove and reinsert the iPod.
•
Switch the iPod from the Pause or Hold position.
•
Reset the iPod as instructed by the device
manufacturer's instructions.
•
Decrease the volume of the unit or of the device.
•
Skip to another song file.
•
Lower the volume or turn off the unit until cool.
•
Ensure the Adapter is securely connected to both
the Jack and to the electrical outlet.
•
Ensure the unit is plugged into an operating
electrical outlet.
•
Remove any material or dirt from the transmitter or
sensor.
•
Replace the batteries as instructed by the "Battery
Installation" subsection.
•
Verify that the battery polarities are correct in the
Battery Compartment and adjust if necessary.
•
Remove and replace the iPod, ensuring the
Connector is unobstructed and the correct Insert is
installed.
•
Refer to the iPod manufacturer's instructions for
troubleshooting information.
•
Reset your iPod (as recommended on Apple web
site.) (Will not effect music stored on your iPod.)
•
Press the Hold switch On/Off (slide it to Hold, then
turn it off).
•
Press and hold the Menu + Select buttons until the
Apple logo appears (10 seconds.) You may need to
repeat this step.