Brookstone Zapi UV User Manual

Zapi UV
Toothbrush
Sanitizer
BaTTERY pRECaUTiOns
• Dispose of the old batteries
properly. Do not dispose of
the old batteries in a fire.
• Do not leave the batteries
where a child or pet could play
with or swallow them. If the
batteries are swallowed, contact
a physician immediately.
• The batteries may explode
if mistreated. Do not attempt
to recharge or disassemble
the batteries.
• Use only fresh batteries of the
required size and type. Do not mix
old and new batteries, different
types of batteries, or rechargeable
batteries of different capacities.
• Alkaline batteries are
recommended for
optimum performance.
CaUTiOn
• Do not immerse Zapi in water
or any kind of liquid.
• Avoid looking directly into the
illuminated light when the unit
is turned on.
• Parts of this device could
present a choking hazard to
young children. Keep out of
reach of children.
• Unit is equipped with a safety
mechanism that will not allow
the unit to go on when the lid
is removed.
• If the bulb should stay lit when the
lid is open, do not look directly into
the lit bulb. Remove the batteries
and call Brookstone® Customer
Service at 800-846-3000.
lOCaTiOn Of COnTROls
1. Toothbrush Hole
2. Cover
3. UV Button
4. Base
5. Drain Hole (on bottom)
1
2
3
4
5
insTalling ThE BaTTERiEs
1. Hold Zapi upside down and
unscrew the base to reach
the battery compartment.
2. Lift the cover to open the battery
compartment and insert 3 AAA
batteries according to the polarity
indicators inside.
3. Close the cover and screw
the base back on to Zapi.
Using Zapi
Important! After brushing your teeth,
shake the excess water off the
toothbrush before inserting it into
the Zapi.
1. With Zapi facing you, hold your
toothbrush with bristles facing
left. Insert into the hole at the
top of the Zapi as shown below.
2. Inside your Zapi there is a rubber
holder. Gently press the handle
of your brush into the holder as
shown in the diagram above.