Care Of Memory Card; Headset Safety - RCA RD1077 User Manual

Before You Begin
Please Respect the
EN
Environment!
Before throwing any
batteries away, consult
your distributor who may
be able to take them back
for specific recycling.

Headset Safety

Have a Blast- Just Not in Your Eardrums
Make sure you turn down
the volume on the unit
before you put on
headphones. Increase the
volume to the desired level
only after headphone are in
place.
• Do not play your headset at a high
volume. Hearing experts warn
against extended high-volume play.
• If you experience a ringing in your
ears, reduce volume or discontinue
use.
• You should use extreme caution or
temporarily discontinue use in
potentially hazardous situations.
Even if your headset is an open-air
type designed to let you hear outside
sounds, don't turn up the volume so
high that you are unable to hear what
is around you.
5

Care of Memory Card

(Not Included)
• Do not touch the golden electrodes.
• Use a soft dry cloth to clean any dirt.
• Do not bend Memory Cards.
• Do not operate or store the
MultiMediaCards in places with
frequent static electricity or electrical
noise (e.g. speaker, TV set). Recorded
data may be damaged.
• It is normal for Memory Card to get
warm after being used for a long time.
• Always put it in storage case after
removing from the unit.
• Do not store Memory Card near fire,
places with high temperature/
humidity or in direct sunlight.
Before You Begin
Important Battery
Information
• When storing the unit , be sure to
remove the battery because they
may leak and damage the unit.
• Battery may leak electrolyte if
inserted incorrectly, if disposed of in
fire, or if an attempt is made to charge
a battery not intended to be
recharged.
• Discard leaky batteries immediately.
Leaking batteries may cause skin burns
or other personal injury.
• Do not charge batteries which are not
intended to be recharged.
• Dispose of batteries, according to
federal, state and local regulations.
Insert battery into the
player
1. To insert battery, push the
battery door away from the unit and
lift the battery door out.
2. Insert a "AAA"(UM4) battery with
polarities corresponding to the
indications in the compartment.
(Refer to "Before You Begin" for
important battery information.)
3. Close the door to the battery
compartment.
Note
Refer to the power level indicator on
display for battery level.
Replace with new battery when the
indicator is empty. Refer to "Display
Overview" on page 11.
EN
6