Table of Contents
Advertisement
r.'
REGULATORY AND REGISTRATION INFORMATION
WARNING
device, pursuant to Subpart
terminals, printers, etc.) certified to comply w ith the Class B limits may be attached to
Operation with non-certified peripherals is likely to result in interference with radio and
NOTE:
modem, etc.) must be shielded in order for this equipment to meet Class B emission limits.
This equipment generates and uses radio frequency energy for its operation and if not installed and
used properly, that is, in strict accordance with the instruction manual, may cause interference with
radio and television reception. It has been tested and found to comply with the
for a Class B computing device which is intended to provide reasonable protection against such interference
in a residential installation. However, there is no guarantee that interference will not occur in
installation. If this equipment does cause interference with radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•
•
•
•
•
•
•
If you need additional help, consult your dealer or ask for assistance from the
service information may be found in the In Case of Difficulty section
find the following booklet helpful: How to Identify and Resolve Radio-TV Interference
is available from the U.S. Government Printing Office, Washington, D.C. 20402 (Stock No.
4).
Registration
To receive the full benefits of your Warranty, complete and mail the accompanying Registration Card.
R�ord the model, series, and serial number of your equipment below. Also record the date purchased.
Refer to this information in any communication you have with Zenith Data Systems
ment
Model
Serial Number
This equipment has been certified to comply with the limits for a Class
-
J
of Part 15 of FCC Rules. Only peripherals (computer input/output devices,
1/0
The
cables that interconnect between this computer and any peripheral (such
Move the computing device away from the receiver
Relocate (turn) the computing device with respect to the receiver.
Reorient the receiver's antenna.
Plug the computing device into a different AC outlet so that the computing device and
receiver are on different branch circuits.
Disconnect and remove any
are a potential source of high
Unplug and remove any circuit boards that not being used. (Here again, unterminated cards
can be a source of potential interference.)
Be
certain that the computing device is plugged into grounded outlet receptades. (Avoid
using AC cheater plugs. Ufting of the power cord ground
and may also present a lethal shock hazard to the user.)
---- -- -- -- -- -- -- -- --
_
__
___ _
being
interfered with.
1/0
cables that are not being used.
RF
emission levels.)
Series
Date Purchased
B
computing
this
computer.
lV
reception.
as
a
printer,
RF
emission limits
particular
a
1/0
(Unterminated
cables
RF
may
increase
emission levels
manufacturer.
Customer
You
of
the manual.
also may
Prob
lems, which
004-000-000345-
regarding
this equip
Advertisement
Table of Contents
