Hasselblad XPan II User Manual page 22

Not For Resale – Free Download at http://www.joe-chan.com/manuals
Exposure #1 displays '± 0.5' (standard)
Exposure #2 displays '-0.5' (under)
Exposure #3 displays '+0.5' (over)
The bracketing function will automatically be deacti-
vated when the camera is turned off and will have to be
reactivated when switched on again. The function can
also be turned off by pressing the MODE button again.
If you release the pressure on the shutter release button (or
remote release) too soon, the operation will not complete.
When depressed again, the sequence will carry on from
where it stopped. That is to say, if you release the pressure
after the first exposure for example, the two final exposures
remain programmed in the camera. Therefore, when you
depress the release again (assuming you have not turned
off the AEB mode or the camera), the first exposure will
be underexposed by 0.5EV and the exposure after that,
overexposed by 0.5EV. The information concerning the
remaining frames remains in the camera even if it has gone
into the standby mode but the AEB symbol and the figures
will be visible again in the camLCD when the camera is
reactivated.
Pay attention to the information in the camLCD when work-
ing in the AEB mode and to remember to cancel this mode
after use either by pressing the AEB button again or by turn-
22
ing off the camera. Failure to do so can cause frames to
be incorrectly exposed as you may have inadvertently
continued an interrupted sequence or started a new one.
The standard exposure will include any exposure
compensation you have set. When using both exposure
compensation and AEB, only the AEB setting will be
shown on the camLCD.
AEB cannot be activated when only one or two pictures
remain unexposed on the film.
The shutter will lock and the camLCD will indicate a
flashing AEB '±' and a number when the bracketing
function is activated in standard format with only three
pictures left and the format switch is changed to
panorama.
The shutter will lock and a flashing P will appear in the
expLCD if the format is changed after one or two
exposures while the camera is set or AEB.
You can any time cancel the AEB by pushing the MODE
button.
AEB cannot be combined with Multi exposure.