Advertisement
Festive Light Pak II™
Multi Flower II
Power Supply:
be sure the source voltage in your area match-
es the required voltage for your American DJ
Moonflower™ before attempting operation. See
the next page for lamp relplacement and breaker
reset.
General Operation:
watch it go. This fixture is designed to oper-
ate as a stand alone unit. It has been tested and the lamp has been
installed at the factory, there is no assembly necessary. The Multi
Flower II™ is ready to be plugged in, out of the box, there is no
power switch. If there is no lamp output check the fuse and bulb. If
the fuse and bulb are good, please return the unit for servicing.
Operating Modes:
This unit comes with a 3-way multi-operating switch located on
the rear of the unit. The switch controls three (3) different operating
modes
Switch in the "I" position: Mode 1 - In this mode the dichoric dish will
spin continuously, regardless of the presence of sound.
Switch in the "0" position: Mode 2 - In this mode the dichroic dish
will remain static.
Switch in the "II" position: Mode 3 - In the this mode the dichoric
dish will only rotate in the prescence of sound. Please note that tap-
ping on the unit, or high pitched sounds may not trigger the unit, the
unit is designed to react to low frequencies (bass). Also note that the
music sensitivity is preset at the factory and may not be changed or
adjusted.
Dichoric Dish:
This unit comes with an additional dichoric dish that can be switched
out at anytime.
1. To switch the dichoric dish, unscrew the thumb screw located at
the front under the lens.
2. Once this has been uscrewed and removed, gently pull the lamp
American DJ
- www.americandj.com - Festive Light Pak II™ Instruction Manual Page 5
©
®
Multi Flower II™ Operation
Before plugging your unit in,
Just plug this light in, and
Festive Light Pak II™
and dichoric dish assembly out of the housing. It does not have to be
removed all the way, just enough to access the dichoric dish.
3. When the dichoric dish is accessible, look behind the dish to see
where it is connected to the motor shaft. Unscrew the phillips screw
that holds the dish in place. You do not need to remove the screw,
®
just loosen the screw enough to slide the dichoric dish out.
4. Once the dish is out, replace with the new dish. Line the phillips
screw up with the mounting hole located on the motor shaft. Screw
the phillips screw into the shaft until the dichoric dish is held into
place firmly and will not slide off.
5. Slide the lamp and dish assembly back into the housing and screw
the thumb screw back into place.
American DJ
- www.americandj.com - Festive Light Pak II™ Instruction Manual Page 6
©
®
Multi Flower II™ Operation
Advertisement
