Peavey AT-200B Owner's Manual page 24

Peavey AT-200B Breakout Box
®
for use with the AT-200
Congratulations on your purchase of the Peavey AT-200B Breakout Box for the AT-200 powered by Antares
Tune for Guitar! With the AT-200B, you can greatly enhance the experience of playing your AT-200 guitar. No need
for batteries– the AT-200B remotely powers the AT-200, ensuring no problems with dead batteries! The included
8-pin DIN cable also carries the guitar's output back down to the box, where a 1/4" output allows you to direct
your signal to your effects or amplifier. In addition, the MIDI jacks on the AT-200B connect the AT-200 guitar to
the world of MIDI control! Software upgrade packages available from Antares will offer a myriad of great new
features for the AT-200, all of which can be controlled via MIDI. Please visit http://autotuneforguitar.com for more
information about software upgrades. By registering your AT-200 at the Antares' Auto-Tune for Guitar web site,
http://autotuneforguitar.com, you become eligible to download any future firmware updates into your guitar using
the AT-200B Breakout Box and a MIDI interface for your computer.
AT-200B Features
1. 9V POWER: This is where you plug in the included 9V power supply. The power supply is a 9V, 500mA, negative
tip supply.
2. OUTPUT: By using the AT-200B, there is no need to use a 1/4" cable from the guitar. The included 8-pin DIN cable
carries the audio down to the breakout box. From there it is routed to this output, which can then be connected
to your effects or directly to your amplifier. (See example 1)
3. TO GUITAR: This is where you plug the included 8-pin DIN cable. Plug the other end into the AT-200 guitar's 8-pin
DIN connector.
4. MIDI IN: If you are using an external MIDI pedal or computer to control the features on the AT-200, plug your
MIDI pedal in here. (See example 2)
5. MIDI THRU: This is a buffered copy of the MIDI IN and is provided for connecting your MIDI controller pedal to a
rack device or MIDI controllable amplifier. (See example 3)
6. MIDI OUT: This output is provided to use along with the MIDI IN to connect your AT-200 to your computer for the
purpose of firmware and software upgrades. Software upgrades are available exclusively from Antares at http://
autotuneforguitar.com. You will need to plug the MIDI IN and OUT to a MIDI interface that is in turn connected
to your computer. Refer to Antares' website for complete instructions. (see example 4)
Auto-Tune
™ ®
Guitar
Auto-
®