Summary of Contents for Canadian Heating Products ECONO-PLUS 36DV-RV
Page 1
ECONO-PLUS 36DV-RV INSTALLING AND OPERATING YOUR ECONO-PLUS 36DV-RV GAS-BURNING FIREPLACE Please leave this manual with the owner CHECK LOCAL CODES PRIOR TO INSTALLATION FOR YOUR SAFETY FOR YOUR SAFETY: IF YOU SMELL GAS: 1. OPEN WINDOWS. DO NOT STORE OR USE ANY FLAMMABLE 2.
INTRODUCTION INSTALLING THE FIREPLACE The Econo Plus 36DV-RV is rated at 16,000 BTUs. (4.16 Kilowatts) The Econo Plus 36DV-RV clearances to combustible materials are for Natural & Propane gas. 0" back, 1" sides, 0" floor and 4" top. The Econo Plus 36DV-RV must The Econo Plus warranty will be voided by, and Econo Plus not be installed any closer than 8 inches to any unprotected disclaims any responsibility for, the following actions:...
INSTALLING THE GAS LINE FOR DETAILED SKETCH OF ALLOWED TERMINATION LOCATIONS SEE APPENDIX A The gas line must be installed before finishing the Econo Plus 36DV-RV Fireplace. Natural Gas requires an inlet pressure of 7" W.C. & a manifold pressure of 3.5" W.C. Propane Gas FOR VINYL SIDING APPLICATIONS ALL ETK requires an inlet pressure of 11"...
VENTING OF REAR VENT DV 3). 45 corner kit. Use a 45 elbow, stucco frame and a 5" The Econo Plus 36DV-RV has been designed for four possible termination. (see figure 7). rear vent installations. 1). Standard 4" or 6" stud walls. For 4" walls use a stucco frame and a 5"...
FIREPLACE MANTEL AND FACING MANTELS & SURROUNDS NOTE: National Canadian Gas Association mantel test Combustible mantels and mouldings may be safely installed requirements are for fire hazard prevention to combustible over the top and on the front of the fireplace provided that they materials.
REMOVAL OF OUTER DOOR INSTALLING LOG SET The EC-Plus 36DV-RV is supplied with four(4) very attractive Easily removed for cleaning and servicing. Although this pane is cultured oak logs. To install simply place log "A's" rectangular made of a very tough tempered glass, always handle it carefully and shaped extension into the log mounting slot located on rear wall place in a safe location where it will not be broken or damaged.
TROUBLESHOOTING PILOT BURNER ADJUSTMENT 1. Remove Pilot Adjustment Cap. (see figure 14) 2. Adjust pilot key to provide properly sized flame. See Figure 15 for properly sized flame. The following is a troubleshooting chart of possible problems: 3. Replace pilot adjustment cap. 4.
Page 8
The Companies warrants the Montigo Gas Appliance to be free from defects in materials and workmanship at the time of manufacture. On the Montigo, there is a ten-year warranty on the firebox and its components, a five-year warranty on the main burner, pilot burner and a one- year warranty on the gas control valve and glass doors.