Hasbro Boombox Specifications

Rockin'
Rockin'
Micro Boombox™
Micro Boombox™
Instruction
Instruction
Playing your HitClip
1.Slide Micro
Music Clip into
the Boombox.
Battery Replacement
1. Your Rockin' Micro
Boombox™ comes with
batteries already installed.
2. To replace batteries,
unscrew battery door lock.
3. Remove exhausted
batteries and dispose of properly.
4. Insert 3 new AAA/LR03 batteries.
5. Replace battery door and tighten screw.
To ensure proper function
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon zinc), or
rechargeable batteries (nickel-cadmium).
- Battery installation should be done by an adult.
- Non-rechargeable batteries are not to be
recharged.
- Rechargeable batteries are to be removed from
the toy before being recharged (if removable).
- Rechargeable batteries are only to be charged
under adult supervision (if removable).
- Only batteries of the same or equivalent type
as recommended are to be used.
- Batteries are to be inserted with correct polarity.
- Exhausted batteries are to be removed from
the toy.
- The supply terminals are not to be short-circuited.
- Do not dispose of batteries in fire, batteries may
explode or leak.
Ages 5 & Up
Asst No. 02014
®
2. Press the Play
button to start
and stop music.
FCC Statement
This device complies with Part 1 5 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part 1 5
of the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on
a circuit different from that to which the
receiver is needed.
- Consult the dealer or an experienced
radio/TV technician for help.