Baxi Solarflo User Manual page 6

Button Function
"Scroll left"
"Break-off"
"Scroll right"
"Confirmation"
6 Solarflo - Solar Thermal Domestic Hot Water System
Description
"Up" • Step up through menu
"+" • Value change: Increase of the indicated value by 1, holding the button down will
automatically increase values
"Call" • Call up of main menu, step down through menu
"Down" • Value change: Decrease of the indicated value by 1, holding the button down will
automatically decrease values
• In main menu, scrolls to the left
"Exit" • Exit current menu
• Exit menu point
• Break-off value change without storing
• In main menu, scrolls to the right
"Choice" • Choosing one menu point
• Confirmation of value change, stores value change
4.0 User controls
4.1.2 Button function
Operation and programming of the Solarflo differential
temperature controller is by means of 4 operating buttons.
By means of pressing these buttons you can:
• recall display values
• carry out controller adjustments
The graphic symbols on the display step through the
operating structure and show clearly the current menu
points, display values or parameters.
Operating buttons have the following functions:
It is not intended that the householder should attempt
to programme the operation of the system so various
parts of the programming menu are not reproduced
here. For further information on programming the
Solar Differential Temperature Controller refer to the
section 3.0 of the Commissioning, Maintenance and
Servicing Guide.
NOTE: Altering some settings could adversely affect the
operation of the Solarflo system, if in doubt contact a
qualified solar installation engineer. Alteration of
functions, not covered in this user guide will invalidate
the warranty.
4.1.3 Menu "Info"
In this menu mode all measured values and operating
states are shown.
If the values are marked as "resettable", they may be
reset in the following way:
Choose the value with buttons
Reset value by means of the button
Message "OK?" confirm with
and
= no or = yes