Invacare FDX User Manual page 96

• Insert the Allen screws (5) including washers again and tighten them.
• If necessary, replace the seat support plate (2) in accordance with the table (see above).
• Put the seat support plate (2) back in position.
• Fit the two Allen screws (7) which are located at the front of the seat support, and connect them
with the crossmembers (4).
• Fit the two Allen screws (8) which are located at the rear of the seat support, and connect them
with the crossmembers (4). It may be necessary to use other holes in the 3 hole pairs for the
screws than you did while dismantling the old plate.
• Fit the two Allen screws (9) at the front of the seat support plate.
• Refit all the parts you have removed.
96