ASSEMBLY:
WHEEL
1 1 . . A A t t t t a a c c h h W W h h e e e e l l s s
Tip body/chassis on its side. Snap wheel onto axle,
with flat side of wheel against chassis. Repeat for
remaining 3 wheels.
BODY
3 3 . . A A t t t t a a c c h h H H a a n n d d l l e e A A s s s s e e m m b b l l y y t t o o B B o o d d y y
Lift body and remove cardboard insert.
RIDGES
SCREWS
CHASSIS
CARD-
BOARD
INSERT
AXLE
HANDLE
RETAINER
FRONT HANDLE
REAR HANDLE
2 2 . . A A s s s s e e m m b b l l e e H H a a n n d d l l e e s s
To snap front and rear handles together: Place rear
handle upside down on flat surface. Holding front
handle with back facing rear handle and perpendicular
to rear handle, snap posts on front handle into holes in
rear handle.
FRONT
HANDLE
Turn body/chassis on its side. Insert front handle
through slot in body.
Fit axle on rear handle into ridges in underside of body.
Place handle retainer over axle (retainer fits only one
way). Using the 4 plain #6 screws and Phillips/cross
head screwdriver, attach retainer to body.
NOTE: If body is locked closed, see back panel for
conversion instructions.
SLOT