Table of Contents
Advertisement
Instructions for use
GB
English,1
WMD 947 P/G/A/K
WASHING MACHINE
Contents
Installation, 2-3-4-5
Connecting the electricity and water supplies
Cutting off the water or electricity supply
Troubleshooting, 13-14
Assistance, 15-16
GB
1
Advertisement
Table of Contents
Related Manuals for Hotpoint WMD 947 P
Summary of Contents for Hotpoint WMD 947 P
-
Page 1: Table Of Contents
Display Running a wash cycle, 8 Wash cycles and functions, 9 Table of wash cycles Wash functions Detergents and laundry, 10 WMD 947 P/G/A/K Detergent dispenser drawer Preparing the laundry Special wash cycles Load balancing system Precautions and tips, 11... -
Page 2: Unpacking And Levelling
Installation 2. If the floor is not perfectly level, compensate for any Keep this instruction manual in a safe place for future referen- unevenness by tightening or loosening the adjustable front ce. Should the appliance be sold, transferred or moved, make feet (see figure);... -
Page 3: Electric Connection
Connecting the drain hose • the supply voltage is included within the values indicated on the Technical details table (see page 5); Connect the drain hose, without bending it, to a • the socket is compatible with the washing machine’s plug. draining duct or a wall drain If this is not the case, replace the socket or the plug. -
Page 4: The First Wash Cycle
The first wash cycle As the colours of the wires in the lead may not correspond with the coloured markings identifyng the terminals in your plug, proceed as follows: Once the appliance has been installed, and before you use Connect Green & Yellow wire to terminal marked E or it for the first time, run a wash cycle with detergent and no or coloured Green or Green &... -
Page 5: Technical Data
Technical data Model WMD 947 P/G/A/K width 59.5 cm Dimensions height 85 cm depth 60 cm Capacity from 1 to 8 kg Electrical please refer to the technical data plate fixed to the machine connections maximum pressure 1 MPa (10 bar) Water connections minimum pressure 0.05 MPa (0.5 bar) -
Page 6: Description Of The Washing Machine
Description of the washing machine Control panel CHILD LOCK SPIN SPEED ON/OFF button button button DISPLAY START/PAUSE Detergent dispenser drawer MEMORY button with button FUNCTION indicator light WASH buttons CYCLE SELECTOR DELAY TEMPERATURE buttons START button button Detergent dispenser drawer: used to dispense deter- CHILD LOCK button: to activate the control panel lock, gents and washing additives (see “Detergents and laundry”). -
Page 7: Display
Display The display is useful when programming the machine and provides a great deal of information. The two upper strings A and B provide details of the wash cycle selected, the wash cycle phase in progress and all informa- tion relating to the progress status of the wash cycle. String C shows the time remaining until the end of the wash cycle in progress and, if a DELAYED START has been set, the time remaining until the start of the selected wash cycle. -
Page 8: Running A Wash Cycle
Running a wash cycle 1. SWITCH THE MACHINE ON. Press the On/Off The functions may affect the recommended load value button ; the text HELLO will appear on the display and/or the duration of the cycle. and the START/PAUSE indicator light will flash slowly in a green colour. -
Page 9: Wash Cycles And Functions
Wash cycles and functions Table of wash cycles Max. load Detergents Max. Max. (kg) Cycle Description of the wash cycle temp. speed duration Wash Fabric Normal Eco (°C) (rpm) softener Wash Everyday wash cycles (Daily) Cottons (*) (1st press of the button): extremely soiled whites. 90°... -
Page 10: Detergents And Laundry
Detergents and laundry Detergent dispenser drawer Special wash cycles Good washing results also depend on the correct dose of Fastwash 30’: this wash cycle was designed to wash detergent: adding too much detergent will not necessarily lightly soiled garments quickly: it lasts just 30 minutes and result in a more efficient wash, and may in fact cause a therefore saves both energy and time. -
Page 11: Precautions And Tips
Precautions and tips Opening the porthole door manually This washing machine was designed and constructed in accordance with international safety regulations. The fol- In the event that it is not possible to open the porthole lowing information is provided for safety reasons and must door due to a powercut, and if you wish to remove the therefore be read carefully. -
Page 12: Care And Maintenance
Care and maintenance Cutting off the water and electricity Cleaning the pump supplies The washing machine is fitted with a self-cleaning pump • Turn off the water tap after every wash cycle. This will limit which does not require any maintenance. Sometimes, wear on the hydraulic system inside the washing machine small items (such as coins or buttons) may fall into the pre- and help to prevent leaks. -
Page 13: Troubleshooting
Troubleshooting Your washing machine could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure that the problem cannot be not solved easily using the following list. Problem: Possible causes / Solutions: The machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. - Page 14 The machine is noisy. • There will always be some motor, pump and drum noise during spin. The machine wont spin properly. • Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly.
-
Page 15: Assistance
Assistance Guarantee 12 Months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you. -
Page 16: After Sales Service
UK: 08448 24 24 24 Republic of Ireland: 01 230 0800 www.hotpointservice.co.uk Indesit Company UK Ltd. Morley Way, Peterborough, PE2 9JB Indesit Company Unit 49 Airways Industrial Estate,Dublin 17 Recycling & Disposal Information As part of Hotpoint’s continued commitment to helping the environment, Hotpoint reserves the right to use quality, recycled components to keep down customer costs and minimise material wastage.