Quick Install; Installation; Unpacking The Box; Choosing A Mounting Location - Maretron TLA100 User Manual

TLA100 User's Manual

1.4 Quick Install

Installing the Maretron TLA100 involves the following steps. Please refer to the individual
sections for additional details.
1. Unpack the Box (Section 2.1)
2. Choose a Mounting Location (Section 2.2)
3. Connect the TLA100 (Section 2.3)
4. Configure or Program the Tank Type (Section 3.1)
5. Configure or Program the Tank Number (Section 3.2)
6. Configure or Program the Operating Mode (Section 3.3)
7. Configure or Program Tank Capacity (Section 3.4)
8. Configure or Program the Resistive Sender type: American or European (Section 3.5.1)
9. Optional – Custom Calibration (Section 3.5.2)

2 Installation

2.1 Unpacking the Box

When unpacking the box containing the Maretron TLA100, you should find the following items.
• 1 - TLA100 Tank Level Adapter
• 1 - TLA100 User's Manual
• 1 - Warranty Registration Card
If any of these items are missing or damaged, please contact Maretron.

2.2 Choosing a Mounting Location

The primary function of the TLA100 is to adapt commercially available resistive tank senders to
®
an NMEA 2000 network so that tank level information can be viewed anywhere on the vessel
where there is an NMEA 2000
analog gauge(s) (referred to as NMEA 2000
standalone to power and sense the resistive sender without an analog gauge(s) (referred to as
®
NMEA 2000 Mode). If you are using the TLA100 with an analog gauge(s) then refer to
Section 2.2.1 for determining an appropriate mounting location and skip Section 2.2.2. If you
are using the TLA100 as a standalone adapter without attaching an analog gauge, then skip
Section 2.2.1 and refer to Section 2.2.2 for determining an appropriate mounting location.

2.2.1 Mounting Location When Used With Analog Gauge(s)

The TLA100 has two primary connections: 1) the NMEA 2000
analog gauge connection. Therefore, the TLA100 should be located between the NMEA 2000
trunk line and the analog gauge(s). The reason for choosing this location is because you will
be connecting some of the wires within the TLA100's permanently attached gray cable to the
gauge and not the actual sender located at the tank. Maretron recommends placing the
TLA100 within 15 feet of the gauge so the TLA100's permanently attached gray cable can be
directly connected to the gauge without any splices (see Figure 1). You may also consider
placing the TLA100 as close as possible to the NMEA 2000
Page 2
www.busse-yachtshop.de | info@busse-yachtshop.de
®
compatible display. The TLA100 can be used together with an
®
/ Analog Gauge Mode), or it can be used
®
network connection, and 2) the
®
trunk line so you can purchase
Revision 1.2
®