Zanussi ZDE 36150W Instruction Booklet page 19

natural phenomenon. To prevent this water from
Iying in the hose or flowing back into the tumble
dryer, it is advisable to drill a small hole (dia. 3
mm) in the lowest point of the hose and to place
a small container below it.(See picture, point B).
you have decided on a fixed wall/window grille, a
good local builder's merchant should be able to
supply you with the necessary fittings and
installation advice.
Important:
condensation problems, it is essential that the
dryer be fitted with the flexible hose to carry its
"exhaust" at least beyond the kitchen units;
preferable outside the kitchen. In order to prevent
the appliance from overheating, it is important
that the steam exhaust is unobstructed.
Therefore, in case of a permanent hose fitted to
an exterior wall or ceiling, it must be ensured an
exhaust capacity of at least 150 m3/h. If the dryer
is fitted next to kitchen units, make sure that the
vent hose is not squashed. If the hose is partially
squashed, drying efficiency will be reduced,
resulting in longer drying times and higher energy
consumption. If the hose is completely squashed,
the safety cut-outs with which the machine is
fitted may operate. When operating the tumble
dryer, the room temperature must not be lower
than +5°C and higher than +35°C, as it may
affect the performance of the appliance.
Once connected to the
dryer, run the vent hose to
the desired outlet point,
ensuring that the run's
overall length is less than
2 m, and that it contains
no more than two bends.
As to the outlet itself, if
It is important not to
connect the vent hose to,
for example, a cooker
hood, or a chimney or flue
pipe designed to carry the
exhaust from a fuel
burning appliance.
Note that to avoid
Electrical connection
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
WARNING:
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability
should this safety measure not be observed.
Important:
Should the appliance power supply cable
need to be replaced, this must be .carried out
by our Service Center.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the appliance's rating plate.
The appliance is supplied with a 13amp plug
fitted.
In the event of having to change the fuse in the
plug supplied, a 13amp ASTA approved (BS1362)
fuse must be used.
Should the plug need to be replaced for any
reason, proceed as described below.
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
Blue
Brown
- Earth
- Neutral
- Live
19