Checking The Oil Level Of The Drive Chain Housing - Yamaha SRX700G Owner's Manual

A B
ESU00172

Checking the oil level of the drive chain housing

WARNING
@
The engine and muffler will be very hot after the
engine has been run. Avoid touching the engine and
muffler while they are still hot with any part of your
body or clothing during inspection or repair.
@
CAUTION :
@
Be sure to have a Yamaha dealer service these items.
@
1. Place the snowmobile on a level surface.
2. When the engine and mufflers are cold, remove the
mufflers.
3. Remove the dipstick 1 and wipe it off with a clean rag.
Then put the dipstick in the hole.
CAUTION :
@
There is a magnet attached to the end of the dipstick.
It is used to remove any metal particles that may
accumulate in the drive chain housing. When remov-
ing the dipstick be sure to:
G
Pull it out slowly and gently so the metal particles
do not fall off the magnet back into the drive
chain housing.
G Wipe off the magnet before reinserting the dip-
stick into the drive chain housing.
@
4. Pull up the dipstick and check that the oil is between
the upper and lower levels. If not, add oil to the upper
level.
2 Upper level
3 Lower level
Drive chain oil: API GL-3
SAE 75 or 80
È For models without reverse transmissions
(SRX700)
É For models with reverse transmissions (not applicable)
8-15