Final Gear Oil - Yamaha RAPTOR 50 Owner's Manual

Tightening torque:
1
Engine oil drain bolt:
2 20 Nm (2.0 m·kgf, 14.5 ft·lbf)
7. Add the specified amount of the recommend-
3
ed engine oil, and then install and tighten the
4 engine oil filler cap.
Recommended oil:
5
See page 10-1.
6 Oil quantity:
0.80 L (0.85 US qt) (0.70 Imp.qt)
7
ECB00300
CAUTION:
8
G In order to prevent clutch slippage (since the
9
engine oil also lubricates the clutch), do not
mix any chemical additives. Do not use oils
10
with a diesel specification of "CD" or oils of
a higher quality than specified. In addition,
11
do not use oils labeled "ENERGY CONSERV-
ING II" or higher.
G
Make sure that no foreign material enters the
crankcase.
8. Start the engine, and then let it idle for several
minutes while checking it for oil leakage. If oil
is leaking, immediately turn the engine off and
check for the cause.
9. Turn the engine off, wait at least ten minutes,
and then check the oil level and correct it if
necessary.
EBU23403

Final gear oil

The final gear case must be checked for oil leak-
age before each ride. If any leakage is found, have
a Yamaha dealer check and repair the ATV. In ad-
dition, the final gear oil level must be checked and
the oil changed as follows at the intervals specified
in the periodic maintenance and lubrication chart.
To check the final gear oil level
1. Place the ATV on a level surface.
NOTE:
The final gear oil level must be checked on a cold
engine.
2. Remove the final gear oil filler cap, wipe the
dipstick off with a clean rag, insert it back into
the oil filler hole (without screwing it in), and
then remove it again to check the oil level.
8-12