Do you have a question about the 57 Series and is the answer not in the manual?
Questions and answers
Summary of Contents for air-o-steam 57 Series
Page 1
USER MANUAL ELECTRIC CONVECTION STEAMER ® air - o - steam Series 57 6 GN 1/1 10 GN 1/1 20 GN 1/1 20 GN 2/1 English Page 1 - 21 Deutsch Page 1 - 22 Français Page 1 - 24 I - 450 - BE, I - 432 - B, I - 456 - BF I - 450 - BE DOC.
Technical data Model Version Rated voltage Control Rated voltage Nominal input Rated Wiring voltage heating elements heating elements output diagram Nr. 5711-3 3N AC 400V 50Hz 230V 230V 9 000W 9 300W 883 606-3 5711-3 3N AC 400V 50Hz 230V 230V 9 000W 9 300W...
Page 3
Fig. 5 Connections Current supply 5 x 2,5mm² PG21 (5711 - 3) 5 x 6mm² PG29 (5712 - 3) 5 x 10mm² PG36 (5714 - 3) 2x (5 x 10mm²) 2x PG29 (5717 - 3) Funnel for descaling agent 5711 - 3 Steam release (5711 - 5714 - 3) 40 x 80 mm...
Unit identification mended for installation and service reasons. Installation and connection 2.1. Installation 2.2. Electrical connection 2.1.1. Table top models See page 6: “Connection of the air-o-steam ® units to 2.1.2. Free-standing floor units the power mains” 2.2. Electrical connection Before connecting the unit check type of power supply 2.2.1.
Page 5
2.3.2. Solid substances Conversion to other degrees of water hardness: Solid substances are e.g. sand or residues from the pip- 1°d = 0,1783 mmol/l ing; to avoid these materials to deposit: insert a filter. = 1,79°F (France) = 1,25°e (Great-Britain) 2.3.3.
Page 6
2.6. General information observed. When preparing food to be cooked at a low Do not block the vapour escape. temperature, for example, a stage lasting 10 - 15 minutes Do not block or cover the safety device (steam re- with a cooking temperature of 150°C must be inserted, lease safety valve).
Page 7
4. Operating instructions Version Fig. 1 I-450-BE...
Page 8
Version VII ON/OFF switch Hot air Steam Steam 1 Steam 2/regeneration Programming the temperature inside the cooking chamber Programming the duration of the cooking cycle Programming the core temperature Waste steam quenching system Manual humidification Warning of scale build-up inside the steam generator Door safety Steam generator level gauge...
Page 9
Version VIII ON/OFF switch Start/Stop Cook Step Fan speed selection Cook & Hold Intermittant fan operation ECO-Delta Cooking Programming the starting time of the cooking cycle Hot air Steam Steam 1 Steam 2/regeneration Programming the temperature inside the cooking chamber Programming the duration of the cooking cycle Programming the core temperature Steam generator discharge...
Page 10
Version X ON/OFF switch Mode “PROG/AUTO” Start/Stop Programme selection Cook Step Fan speed selector Cook & Hold Intermittent fan operation ECO-Delta Cooking Programming the starting time of the cooking cycle Hot air Steam Steam 1 Steam 2/regeneration Indication of the actual temperature value Regulation of the moisture degree Programming the temperature inside the cooking chamber...
Page 11
4.1. Control panel - version VI 10 minutes. In the ”STEAM” cooking mode, the temperature is automatically limited to 100 °C. In the ”STEAM 1" and ”STEAM 2” cooking modes, the programmable maximum temperature is 250° C. In the MAIN SWITCH (Fig.1 No.1) ”LOW-TEMPERATURE STEAM"...
Page 12
4.2. Control panel - version VII 10 minutes. In the ”STEAM” cooking mode, the temperature is automatically limited to 100 °C. In the ”STEAM 1" and ”STEAM 2” cooking modes, the programmable maximum temperature is 250° C. In the ”LOW-TEMPERATURE MAIN SWITCH (Fig.2 No.1) STEAM”...
Page 13
When the appliance is switched off, this is indicated by thermostatic waste steam quenching system in all the the green indicator light above the button going out. When cooking modes. If the air-o-steam ® is placed under a steam the appliance is switched on it lights up.
Page 14
STEAM 1 (Fig.3 No.13) INTERMITTENT FAN OPERATION (Fig.3 No.8) In this position the heating of the cooking chamber is Intermittent fan operation is obtained in this position, i.e. the fan starts and stops at programmed intervals. This activated as well as the steam generator heating elements intermittent control is activated when the regulator stops in the proportion of 75% hot air and 25% steam.
It should be activated regularly at the end of a generator and on the heating elements. Descaling should working day with the air-o-steam ® in order to clean the be carried out as quickly as possible.
4.4 Control panel - version COOK-STEP (Fig.4 No.5) With this COOK-STEP storage, a cooking of cycle consisting of six different sequences may be set: e.g. ON/OFF SWITCH (Fig.4 No.1) browning, cooking and keeping the food warm. Programming the sequences is described under ”Storage The ON/OFF switch is used to switch the appliance and of cooking programmes”.
Page 18
It should be activated regularly at the end of a this means that there is a build-up of scale in the steam ® working day with the air-o-steam in order to clean the generator and on the heating elements. Descaling should appliance.
Page 19
STORAGE OF COOKING PROGRAMMES CHANGING AND COMPLETING COOKING PROGRAM- To store a COOK-STEP or a set sequence in the ”PROG” mode under a well-defined programme number, press the To change a stored programme, proceed as for the erasing stage. Follow the same sequence of operations described buttons simultaneously for about 1.5 seconds.
4. Never use sharp objects on the seal. flushing through with water. ® 5. The convection-steamers air-o-steam are protected The filter must always be inserted in the cooking chamber. against water jets (type of protection IPX5). This type...
Page 21
Dear Sir/Madam, first sign of hardening, breaking or cracking. Apart from the regular cleaning and maintenance ® operations, your air-o-steam appliance should undergo To replace, proceed as follows: maintenance by a qualified technician to ensure that its Manually remove the seal from its groove.
Need help?
Do you have a question about the 57 Series and is the answer not in the manual?
Questions and answers