Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Activeforever AquaGuard
- Page 1 OWNER’S MANUAL Revision 1.3 www.ActiveForever.com...
-
Page 2: Table Of Contents
Contacting RJE Technologies, Inc................1 SAFETY PRECAUTIONS ................... 2 General Swimming Pool Safety Guidelines ............2 QUICK REFERENCE GUIDE..................3 ABOUT THE AQUAGUARD POOL ALARM SYSTEM ..........4 System Components ....................4 Controls and Indicators ................... 4 Swimming Pool Alarm Operation ................4 ASSEMBLING THE AQUAGUARD SYSTEM ............ -
Page 3: Introduction
The AquaGuard Pool Alarm System is an important safety addition to your swimming pool or spa. usage. component, part or accessory, which AquaGuard™ However, AquaGuard by itself is not a lifesaving device and does not take the place of proper adult determines to have become defective through abuse Items consumed through use. -
Page 4: Safety Precautions
SAFETY PRECAUTIONS Unit into “armed” mode. Important! The AquaGuard system is a pool alarm; not a life-saving device. It should be used Testing the System along with other safety equipment and precautions. It is intended to provide an additional level of It is strongly recommended that a System Test be performed periodically using the procedure security to your pool and/or spa. -
Page 5: Quick Reference Guide
(no cracks, breaks, deformation, etc.). Make sure the bottom of the sensor tube is 5 - 6 The following is a “quick reference” guide to operating your AquaGuard Pool Alarm System. Refer inches (13 – 15 cm) below the surface of the water. Add water to the pool, or install the... -
Page 6: About The Aquaguard Pool Alarm System
Indication Condition Response Detector Unit Remote Unit The AquaGuard Pool Alarm System is designed to detect a child, pet or object of a minimum size Fall or activity in the pool Siren sounds. Siren sounds. • Press any key on the Detector Unit keypad;... -
Page 7: Assembling The Aquaguard System
You can use the LED indicators and alarm siren on the Detector Unit or the Remote Unit to monitor Install four “D” size batteries in the battery compartment. the current state of your AquaGuard system. The following table shows a list of possible system The unit is now on and is calibrating. -
Page 8: Assembling The Detector Base Unit And Sensor Tube
Pool cleaners (sweeps) that move around the pool, climb the pool walls, and fall back into • the pool can look like a small child to the AquaGuard system. False alarms can occur if the pool sweep hits the Sensor Tube. -
Page 9: Tools Required
Enter 1234 on the Detector unit keypad to deactivate the "anti-theft" In order to properly detect, the AquaGuard Detector Unit must be installed within 22 feet (7 alarm. - Page 10 • Remote Unit alarms should sound. The AquaGuard system uses a radio transmitter/receiver to allow communication between If the alarms do not sound, it may be necessary to change the location of the Detector the Detector Unit and the Remote Unit. You must establish the radio link to use the Remote Unit.
Need help?
Do you have a question about the AquaGuard and is the answer not in the manual?
Questions and answers