Table of Contents
Advertisement
Connections
Connecting to a TV equipped with component video inputs
If your TV has component video inputs, you can obtain pictures in better quality.
TV or monitor equipped with
component video inputs
Component video outputs/inputs
Some TVs or monitors are equipped with component
video inputs. Connecting to these inputs allows you to
enjoy higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex.Y, R-Y, R-B or
Y, C
, C
)
B
R
In some TVs or monitors, the color levels of the
playback picture may be reduced slightly or the tint
may change. In such a case, adjust the TV or monitor
for optimum performance.
To switch the output signal (Progressive/Interlaced)
Press PROGRESSIVE on the remote
PROGRESSIVE
control.
The output signal alternates between
component progressive and component
interlaced.
• When "PSO" is displayed on the front panel
display, the output signal is progressive. When
"PSO" is not displayed, the output signal is
interlace.
Notes
• Refer to the owner's manual of the connected TV as well.
• When you connect the recorder to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before any connections.
• If you place the recorder near a tuner or radio, the radio broadcast sound might be distorted. In this event, place the recorder
away from the tuner and radio.
• The output sound of the recorder has a wide dynamic range. Be sure to adjust the amplifier's volume to a moderate listening
level. Otherwise, the speakers and your hearing may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the recorder's power cord. If you leave the amplifier power on, the
speakers may be damaged.
• Consumers should note that not all high definition television sets are fully compatible with this product and may cause
artifacts to be displayed in the picture. In case of 625 progressive scan picture problems, it is recommended that the user
switch the connection to the "Standard Definition" output. If there are questions regarding our TV set compatibility with this
model 625p DVD player, please contact our Customer Service Center.
03_D-R150SB(E)_inst_13-20
Video cable (not supplied)
To Y video input
To P
video input
B
To P
video input
R
To
COMPONENT
OUT P
R
To AV OUT AUDIO
(R: red)
17
To
COMPONENT
To audio inputs of the amplifier
OUT P
B
To
COMPONENT
OUT Y
To AV OUT AUDIO
(L: white)
Audio cable (not supplied)
• The following setting is required according to the TV
that you are connecting. Perform this setting after step
4 (
page 15).
Setting "AV1 output" on the
"Initial settings" menu.
page 38
TV
TV or monitor
equipped with
"Video" or "S-Video"
component video
inputs
• Selecting "RGB" disables signal output from the
COMPONENT OUT (Y, P
B
display disappears immediately after you select "RGB",
you can restore it by connecting the recorder using the
AV OUT VIDEO (yellow) jack.
• If you display the setup menu when the output signal is
progressive, it automatically changes to interlace.
Press PROGRESSIVE again after you exit the menu.
05.7.13, 0:23 AM
(red)
(white)
"Audio out select" on the
"Picture/Audio settings"
menu.
page 40
"Analog 2ch"
, P
) jacks. If the on-screen
R
17
Advertisement
Table of Contents
