Cleaning The Unit; Input Attenuator Setting; Resetting The Receiver - Pioneer SX-315 Operating Instruction

SX-315.book Page 25 Friday, February 3, 2006 12:18 PM
Additional information
Note
• If the unit does not operate normally due to external
effects such as static electricity, disconnect the
power plug from the outlet and insert again to return
to normal operating conditions.

Cleaning the unit

• Use a polishing cloth or dry cloth to wipe off dust and
dirt.
• When the surface is dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six
times with water, and wrung out well, and then wipe
again with a dry cloth. Do not use furniture wax or
cleansers.
• Never use thinners, benzine, insecticide sprays or
other chemicals on or near this unit, since these will
corrode the surface.

Input attenuator setting

• Default setting: ATT:OFF
If you experience distortion when you select the TAPE/
VCR input it may be that the input level is too high.
Switching on the input attenuator lowers the input level,
restoring the proper sound.
1 Press SYSTEM SETUP repeatedly until the input
attenuator setting is shown in the display.
The display shows ATT:ON or ATT:OFF for Input
attenuator on and off respectively.
2 Use the (cursor left/right) buttons to
change the setting.
• You can also use the < and > buttons on the front
panel.
3 Press ENTER to exit System Setup.

Resetting the receiver

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 Press TONE and SYSTEM SETUP at the same time.
3 When you see RESET? appear in the display,
press the > button.
OK? shows in the display.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
Note
• Steps 3 and 4 must be completed within five
seconds, otherwise the receiver will exit the reset
process.
07
25
En