Using Usb Wireless Lan Card - Mvix BOX User Manual

Appendix.
C. Using USB wireless LAN card
1. Install the USB wireless LAN card provided to USB host. When installation is recognized, a single beep is produced.
2. In Mvixbox, login with sysadmin account. Then, select network setting menu.
Note. USB wireless LAN card provided per manufacturer
Manufacturer
UNICORN
D-LINK
IP-TIME
ANYGATE
Contents of the above table are on LAN card that uses Ralink 2571 chip driver.
Chip sets/ model names to be added can be checked in http://www.mvix.net or http://www.eunicorn.co.kr.
Model Chipset
TW-54G
DWA-110
RT2571
G054U-2
XM-152
3. Select 'Wireless' in wired/ wireless setup to
display wireless setup at the bottom.
4. Enter ESSID of wired/ wireless IP Router (or
AP) to be connected to ESSID
If the wired/ wireless IP Router (or AP)
is applied with security setup, make input with
the same setup.
(Caution. Capital/ small letters are distinguished
and accurate input is necessary. If not, wireless
connection is not possible.)
Note. Using of DHCP (automatic IP address) is
optional. When IP of Mvixbox is changed, set IP
with the same network as sharer, etc.
if it is difficult to check the IP change.
90
Unicorn Information System