Operating The Tv With The Remote Control; Troubleshooting Chart - Sharp CP-SW1000W Operation Manual

Operating the TV with the remote
CP-SW1000W
control
ENGLISH
You can operate SHARP TV with this system's remote control.
Watching TV
Point the remote control at the TV.
1
Press the TV POWER button to turn on the TV.
2
Press the CH UP
channel.
Pressing the CH UP
channel switching.
3
Press TV VOL + or – button to adjust the TV volume.
Other operable button
Press the Input Select button to switch the input source. (TV)
Note:
Some models of SHARP TV may not be operable. In this case, use
the remote control supplied with each product.
E-9
TV operation buttons
or CH DOWN button to set the
or CH DOWN button enables TV

Troubleshooting chart

Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
Symptom
No sound is heard. Is the input signal (selection) set properly?
Is the volume level set to "0"?
Noise is heard Move the subwoofer away from any
during playback. computers or mobile phones.
When a button is Set this unit to the stand-by mode and
pressed, the unit then turn it back on.
does not respond.
The power is not Is the unit unplugged? (Refer to page 6)
turned on. The protection circuit may be activated.
Unplug and plug in the power lead again
after 5 minutes or more.
Remote control
Symptom
The remote control Is the battery polarity correct?
does not operate Is the battery dead?
properly. Is the distance or angle incorrect?
Are there any obstructions in front of the
subwoofer?
Is there a
remote sensor?
Is the
equipment used simultaneously?
The subwoofer Is the AC power lead of the subwoofer
cannot be turned on plugged in?
with the remote Is the battery inserted?
control.
TV cannot be Depending on the model, some or all
operated with the functions may not be operable using the
remote control. remote control of this unit. In this case, use
the remote control supplied with the TV.
Possible cause
Possible cause
strong light shining on the
remote control for another