Setting Up Your New Digital Camera System; Installing The Batteries; Replacing Worn-Out Batteries - UMAX Technologies ASTRACAM Owner's Manual

SETTING UP
YOUR NEW DIGITAL CAMERA SYSTEM

Installing the Batteries

Important Battery Usage Guides: Read Before Using the AstraCam.
WARNING: Improperly inserting the rechargeable batteries (wrong polarity)
may cause damage to your camera and will void the warranty. See the guide
symbols inside the battery case for proper installation of the batteries.
WARNING: Non-rechargeable AAA batteries can be used temporarily to take
photos. However, these batteries must be removed prior to putting the camera in
the cradle. Failure to remove all non-rechargeable batteries before placing the
camera in the cradle may cause damage to the camera, voiding the warranty
and/or causing the batteries to discharge or explode, which may result in bodily
injury.
To put the rechargeable batteries in the AstraCam:
1. Unwrap the 2 AAA rechargeable batteries. Note the
polarity symbols near the ends of each battery.
2. Open the battery cover at the bottom of the camera by
pushing the cover out with your thumb.
3. Note the +/- polarity symbols on the contacts attached
to the inside of the cover. Insert each battery so that
the polarity symbol of the exposed end of each battery
matches the polarity symbols on the contacts inside the
battery compartment.
4. Close the cover.
Note: Before charging the batteries, you must install the
AstraCam cradle. See page 5, "Connecting the AstraCam
Cradle." When the cradle is connected, place the
AstraCam in the cradle to charge the batteries. The charge
time for the batteries is up to 2.6 hours.

Replacing Worn-Out Batteries

Replace the batteries only with AAA size, 1.2V, nickel metal hydride
rechargeable batteries.
AstraCam Owner's Guide
AstraCam
Bottom View
3