Table of Contents
Advertisement
MAINTENANCE AND CLEANING
Before any maintenance or cleaning work is
carried out, DISCONNECT the appliance from
the ELECTRICITY supply.
Internal cleaning
Clean the inside and accessories with warm
water and bicarbonate of soda (5ml to 0.5 litre
of water). Rinse and dry thoroughly.
NEVER USE DETERGENTS, ABRASIVE
POWDERS, HIGHLY PERFUMED
CLEANING PRODUCTS OR WAX
POLISHES, TO CLEAN THE INTERIOR
AS THESE WILL DAMAGE THE
SURFACE AND LEAVE A STRONG
SMELL.
Clean the drain hole of the water trough at
regular intervals and make sure that the drain
hole is never obstructed, so that the defrost
water may flow freely.
External cleaning
Wash the outer cabinet with warm soapy water.
Do NOT use abrasive products.
Once or twice a year dust the condenser (black
grill) and the compressor at the back of the
appliance, with a brush or vacuum cleaner, see
Fig.13.
D273
You MUST ensure that the appliance is
switched OFF. An accumulation of dust will
affect the performance of the appliance and
cause excessive electricity consumption.
Fig. 14
CONDENSER
DEFROST
TRAY
COMPRESSOR
When the appliance is not in use
When the appliance is not in use for long
periods, disconnect from the electricity supply,
empty all foods and clean the appliance, leaving
the doors ajar to prevent unpleasant smells.
Changing the light bulb
Should the interior light fail to work, first switch
off the appliance and disconnect from the
electricity supply, then replace the bulb as
follows;
D411
unscrew the light cover and then pull it outward
by pressing as shown in the Fig. 14. Unscrew
the bulb and replace it with a new 15 watt bulb
(available from your nearest Zanussi Service
Force Centre).
Replace the light cover by sliding it into its
original position and replacing the screw.
GB
Fig. 15
13
Advertisement
Table of Contents
