Table of Contents
Advertisement
DESCRIPTION OF THE APPLIANCE
J
I
H
G
F
A - Thermostat control for both compartments
B - Dairy compartment
C - Can storage shelf
D - Movable shelf
E - Bottle storage shelf
F - Compartment for freezing fresh food
G - Compartment for frozen food storage
H - Salad crispers
I - Glass shelf
J - Storage shelves
4
Door reversal directions
1. Disconnect from the electricity supply.
2. Remove all loose items, including food, store
food in a cool place.
3. Remove the ventilation grill (D).
4. Unscrew the bottom hinge (E).
5. Remove the freezer door by releasing it from the
A
middle hinge (H).
6. Unscrew the middle hinge.
B
7. Slide out the fridge door from pin (G), unscrew
the latter and then screw it down into the hinge
provided on the opposite side, after having
removed the small plugs which should then be
C
fitted on the opposite side.
8. Refit the fridge door and replace the middle hinge
to the left hand side.
D
9. Replace the door and bottom hinge (E) on the
opposite side.
10.Remove the plug (F) from the ventilation grill (D)
and replace it on the opposite side. Re-assemble
E
the ventilation grill (D).
11. Remove the handles and refit them on the
opposite side. The holes that are not used are to
be masked with the plastic plugs removed.
The doors can be aligned by adjustung the middle
hinge, with help of a tool, after having slackened the
two screws.
After having reversed the opening direction of the
doors check that all the screws are properly
tightened and that the magnetic seal adheres to the
cabinet.
Attention
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdryer.
PR220
Printed on recyclated paper
F
E
F
F
D
F
H
G
17
Advertisement
Table of Contents
