How to Use
Uso
Pulizia del contenitore raccoglipolvere
Pull out
Estrarre
Tank Separation Lever
Leva di sblocco del contenitore
CAUTION
After emptying the dust tank the indicator is lighted
on(Red light) or twinkles, clean the dust tank.
Check the indicator is lighted on after emptying the dust tank.
If the indicator is lighted on when dust tank is not filled, firstly clean
the dust tank and air guide as follows.
• Press the lever of tank handle and pull the dust tank out.
• Empty dust tank by pressing the dust emptying button as figure.
• Open the dust tank cap by pushing the cap separating button.
• Rotate the air guide by counter clock wise and pull it out of the dust tank.
The air guide is located in the center of dust tank.
• Wash tank and air guide with water.
• Dry those fully in shade so that moisture is entirely removed.
Dust tank cap assembling
• The hook of the dust tank cap fits the groove of dust tank.
• Push the dust tank cap until the button of the dust tank
assemble the dust tank cap.
Air guide assembling
• Adjust the arrow on air guide to the rib of the dust tank.
• Join the air guide to the dust tank by rotating it clock wise.
Montaggio della guida dell'aria
• Allineare la freccia sulla guida dell'aria con l'indicatore del contenitore.
• Attaccare la guida dell'aria al contenitore ruotandola in senso orario.
Rib
Indicatore
10
P/No 3828Fi2866D
Cleaning the Dust Tank
Air guide
Guida dell'aria
Dopo aver svuotato il contenitore, verificare se la spia è accesa.
Se la spia si accende ma il contenitore non è pieno, pulire il contenitore e le guide
dell'aria come segue.
• Premere la leva della maniglia del contenitore ed estrarre il contenitore raccoglipolvere.
• Svuotare il sacchetto della polvere premendo il tasto come mostrato in figura.
• Aprire il coperchio del contenitore premendo il tasto di sblocco.
• Ruotare la guida in senso antiorario e rimuoverla dal contenitore.
La guida dell'aria è situata al centro del contenitore raccoglipolvere.
• Lavare il contenitore e la guida con acqua.
• Farli asciugare completamente all'ombra.
Montaggio del coperchio del contenitore raccoglipolvere
• Il gancio del coperchio del contenitore va inserito nella scanalatura sul
contenitore.
• Spingere il coperchio fino a inserirlo correttamente in sede.
Dust emptying button
Tasto di svuotamento della polvere
Dust separating
button
Tasto di sblocco
Push
del contenitore
Spingere
AVVERTENZA
Se dopo aver svuotato il contenitore, la spia è accesa (rossa) o lampeggiante,
pulire il contenitore.
Hook
Gancio
Groove
Scanalatura
Dust tank cap
Coperchio del contenitore raccoglipolvere