Thermador VTN 1080 F Instalation Manual

Ventilation
Hide thumbs Also See for VTN 1080 F:

Advertisement

DOWNDRAFT
DOWNDRAFT
VENTILATION
USE AND CARE MANUAL

INSTALLATION MANUAL

USE AND CARE MANUAL
MODELS: CVS2
MODEL: VTN 1080 F
MODELS: UCV2

Advertisement

Table of Contents
loading

Summary of Contents for Thermador VTN 1080 F

  • Page 1: Installation Manual

    DOWNDRAFT DOWNDRAFT VENTILATION USE AND CARE MANUAL INSTALLATION MANUAL USE AND CARE MANUAL MODELS: CVS2 MODEL: VTN 1080 F MODELS: UCV2...
  • Page 3: Safety Instructions

    SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS. This appliance conforms to the relevant WARNING – to reduce the risk of fire, safety regulations. electric shock, or injury to persons, observe the following: Repairs should only be carried out by qualified specialists. A.
  • Page 4: Instructions De Sécurité Importantes

    INSTRUCTIONS DE SÉCURITÉ IMPORTANTES LIRE ET CONSERVER CES INSTRUCTIONS. Cet appareil est conforme aux règlements AVERTISSEMENT – pour réduire le risque d’incendie, de choc électrique ou de de sécurité pertinents. préjudice physique, respectez les consignes Les réparations doivent uniquement être suivantes : effectuées par des spécialistes qualifiés.
  • Page 5: Instrucciones De Seguridad Importantes

    INSTRUCCIONES DE SEGURIDAD IMPORTANTES LEA Y CONSERVE ESTAS INSTRUCCIONES. Este electrodoméstico cumple con las ADVERTENCIA – para reducir el riesgo de incendio, descarga eléctrica o lesiones a reglamentaciones de seguridad personas, siga estas indicaciones: correspondientes. A. El trabajo de instalación y el cableado Las reparaciones deben ser realizadas por eléctrico deben ser realizados por especialistas calificados únicamente.
  • Page 6: Installation Instalación

    INSTALLATION INSTALACIÓN 1. Place the hood on a stable surface. Remove the grease filters. 1. Placez la hotte sur une surface stable. Retirez les filtres à graisse. 1. Coloque la campana sobre una superfi- cie estable. Retire los filtros de grasa. 2.
  • Page 7 3. Remove the round duct plate. 3. Retirez la plaque de conduit rond. 3. Retire la placa del conducto redondo. 4. Screw the round duct plate to the fan. 4. Vissez la plaque de conduit rond au ventilateur. 4. Atornille la placa del conducto redondo al ventilador.
  • Page 8 5. Attach the fan on both sides and careful- ly lift it over the lighting strip. CAUTION: Crushing Hazard! 5. Fixez le ventilateur sur les deux côtés et soulevez-le délicatement par-dessus la lamelle pare-foudre. MISE EN GARDE : Danger d'écrasement! 5.
  • Page 9 7. Screw the fan to the hood. 7. Vissez le ventilateur à la hotte. 7. Atornille el ventilador a la campana. 8. Connect electrical cables between the fan and hood. The plug-and-socket connections of the electric cables must be located inside the building, according to local codes.
  • Page 10: Wire Diagram

    WIRE DIAGRAM...
  • Page 11: Schéma De Câblage

    SCHÉMA DE CÂBLAGE...
  • Page 12: Diagrama De Cabelado

    DIAGRAMA DE CABELADO...
  • Page 13 Notes...
  • Page 14 Notes...
  • Page 15 Noticias...
  • Page 16 5551 McFadden Avenue, Huntington Beach, CA 92649 • 1-800-735-4328 • www.thermador.com 9000314791 • 10013 Rev B • 02/08 © BSH Home Appliances Corporation • Litho U.S.A. 9000 314 791 Printed in Germany 0308 Es.

Table of Contents