Siemens Gas hob Installation Instructions Manual page 5

Replace the pan supports, burner lids and burner rings,
4.
checking that they are correctly positioned.
These burners do not require the primary air to be adjusted.
B) Adjusting the gas taps – picture 6:
Turn all control knobs to the off setting.
1.
Pull off the control knobs. After removal, the flexible rubber
2.
knob gasket can be seen. Do not remove the knob gasket.
Using the tip of the screwdriver, carefully push the knob gasket
to one side to gain access to the minimum flame nozzle.
Turn the minimum flame nozzle with a slotted screwdriver to
3.
set the supply of gas to a minimum.
Depending on the type of gas to which you are converting,
carry out the following steps (see table):
* *
* '
* '
* % %
* & &
* % %
– A: Screw the minimum flame nozzle fully in.
– B: Screw the minimum flame nozzles in until the flames do
not go out or jump back when the control knob is turned
from high to low flame.
– C: Minimum flame nozzles have to be changed by an
authorised specialist. Screw the minimum flame nozzles in
firmly:
*   PEDU
– D: Do not make any modifications to the minimum flame
nozzles.
Refit the control knob.
4.
Note: Apply the label showing the converted gas type to the
rating plate.
* * *
$ &
$ &
&
&
' &
$ % &
  
$
$
'
&
:2. '