Please Read The Following Carefully - Central Pneumatic 95014 Assembly And Operating Instructions Manual

Supply Valve (18), Throttling Valve (18A), and Abrasive Control Valve (18B) to
the "OFF" position. Use the Safety Valve (10) to release any remaining air
pressure in the Tank (1). check to make sure the Pressure gauge reads "0"
PSI. Then, disconnect the compressor hose from the Inlet Connector (19) of the
unit.
2. Before each use: Inspect the general condition of the Pressurized Abrasive
Blaster and its accessories. Check for loose screws, misalignment or binding
of moving parts, cracked or broken parts, damaged air hoses, and any other
condition that may affect safe operation. If abnormal noise or vibration
occurs, have the problem corrected before further use. Do not use damaged
equipment.
3. Before, during, and after use: Periodically, check the Water Trap (17) for
excessive water build-up. If necessary, hold a container beneath the Water Trap
and press the button located at the bottom of the Water Trap to drain the water.
4. To clean the exterior of the Pressurized Abrasive Blaster, wipe with a clean,
damp cloth using a mild detergent or mild solvent. Do not immerse the tool in
liquids.
5. When storing, always store the Pressurized Abrasive Blaster in a clean, dry,
safe location out of reach of children and other unauthorized people.
6. cAUTIOn! All maintenance, service, and repairs not mentioned in this
manual must only be performed by a qualified service technician.

PLEASE READ ThE FOLLOWIng cAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND
ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY
PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY
THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT
PARTS THERETO.
For technical questions, please call 1-800-444-3353
SKU 95014 PAGE 13