Gas Line Connection; Installing Hood - White Mountain Hearth VFS32FB2DF-3 Owner's Manual

Universal firebox for all vent-free log sets

Table of Contents

extended hoods

If your non-combustible facing material is over 1" in thickness that will be used to finish this firebox, an extended hood is available that

will extend out 2" farther out into the room. Contact your local dealer for details.

VB4H32BL

Standard Black

VB4H32BR

Polished Brass

VB4H32SS

Stainless Steel

VB4H32HP

Hammered Pewter

Finishing

All joints (top, bottom and sides), where the wall or decorative facing material meets the firebox surround should be sealed with a non-

combustible material.

Hearth extensions are recommended, but not required for these fireboxes.

The firebox is designed to accept a 3/8-inch gas line for an approved

vent-free gas logset. Have the line installed by a qualified service

person in accordance with all building codes. consult local building

codes to properly size the gas supply line leading to the 3/8-inch

hook-up at the unit. the state of Massachusetts requires that a

flexible appliance connector cannot exceed three feet in length.

Gas access holes are provided on both sides of the firebox. See

Figure 10. carefully remove the indented knockout in the ceramic

brick panel using a drill or utility knife. See Figure 11.

check gas type. Use only the gas type indicated on the gas log

set rating plate. if the gas listed on the plate is not your type of

gas supply, Do not inStaLL. contact your dealer for proper

model.

Always use an external regulator for all LP fireboxes to reduce the

supply tank pressure to a maximum of 14" w.c. This is in addition

to the regulator fitted to the log set.

Wa R n i n g : c o n n E c t i o n D i R E c t LY to a n

UnREgULatED L.P. tanK can caUSE EXPLoSion.

Install only a ANSI Z21.11.2 vent-free log set into this firebox.

Page 8

inStaLLing HooD (continued)

VB4H36BL

VB4H36BR

VB4H36SS

VB4H36HP