Panasonic Viera TX-L32ET5Y Operating Instructions Manual page 98

Problem
Chaotic image, noisy
No image can be
displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is
displayed
No sound is produced
Sound level is low or
sound is distorted
Cannot view 3D images
There is something wrong
with the 3D images
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Cannot connect to the
network
Cannot select the file
during DLNA operations
Cannot operate
VIERA Connect
98
Set [P-NR] in the Picture Menu to remove noise.
Check nearby electrical products (car, motorcycle, fluorescent lamp).
Is [Contrast], [Brightness] or [Colour] in the Picture Menu set to the minimum?
(p. 36)
Check the setting of [AV2] ([COMPONENT] / [VIDEO]) in [Input Selection] to
match the output of the external equipment. (p. 28)
Reset channels. (p. 44, 45)
Turn the TV off with Mains power On / Off switch, then turn it on again.
If the problem persists, initialise all settings.
Is "Sound mute" active?
Is the volume set to the minimum?
Sound signal reception may be deteriorated.
Set [MPX] (p. 38) in the Sound Menu to [Mono]. (Analogue)
Ensure that [3D Mode Selection] is set to [3D].
Some 3D image signals may not be automatically recognised as 3D images.
Set [3D Mode Selection (Manual)] to match the picture format.
For some people, the 3D images may be difficult to see, or cannot be seen,
especially in users who have a different level of eyesight between the left and
right eyes. Take the necessary steps (wearing glasses etc.) to correct your
eyesight before use.
Check the setting of [Edge Smoother].
Set the sound setting of the connected equipment to "2ch L.PCM".
Check the [HDMI1 / 2 / 3 / 4 Input] setting in the Sound Menu.
If digital sound connection has a problem, select analogue sound connection.
(p. 94)
Check the HDMI cable is connected properly.
Turn the TV and equipment off, then turn them on again.
Check an input signal from the equipment.
Use equipment compliant with EIA/CEA-861/861D.
Check the LAN cable or wireless LAN is connected properly.
Check the connections and settings.
Check the network equipment and network environment.
The router may not be set to issue IP address automatically. If the network
administrator prefers to allocate an IP address, set an IP address manually.
(p. 72)
The router may be using MAC address filtering (security setting).
Confirm the MAC Address of this TV (p. 40) and set the router to use it.
If the problem persists, consult your Internet Service Provider or
telecommunications company.
Is media server of the connected equipment prepared?
Check applicable data format.
Check the connections and settings.
The server or connected line may be busy now.
Causes / Actions
(p. 36)
[Shipping Condition] (p. 56)
(p. 9)
(p. 31)
(p. 33)
(p. 87)
(p. 95)
(p. 70 - 74)
(p. 90, 91)
(p. 70 - 74)
(p. 32)
(p. 39)
(p. 70)
(p. 69)