Download Print this page

Precautions - Aiwa ADC-WRF35 Operating Instructions Manual

Compact disc changer

Advertisement

PRECAUTIONS

• Do NOT install the unit in a location where it
may be subjected to:
— Direct sunlight or other sources of excessive
heat
— Fluid, rain or moisture
— Excessive dirt or dust
— Excessive vibration
• This unit is designed to be operated on a 12-volt
DC negative-ground electrical system only.
• Choose the mounting location carefully so that
the unit will not interfere with normal driving
functions.
• Berore making connections, disconnect the (
terminal of the car battery to avoid short
circuiting.
• Be sure to connect the red power input lead to
the positive 12-V power terminal, to which power
is supplied when the ignition key is in the
accessory position.
• The power unit & FM modulator is designed
only for this ADC-M35 compact disc changer.
Notes on CDs
• A defective or soiled disc stored in the disc
magazine can cause the sound to drop out
during play.
• Always handle a disc by holding its inner and
outer edges.
• Do NOT touch the surface of the unlabeled side
of the disc.
• Do NOT attach paper or tape etc. to a disc.
• Do NOT expose the discs to direct sunlight or
excessive heat.
• Clean the discs before inserting them into the
disc magazine. Always clean a disc from the
center outward with a cleaning cloth.
• NEVER use solvents such as benzine or alcohol
to clean a disc.
• You cannot play an 8-cm (3-inch) CD — even
with the specially designed adaptor.
Notes on the disc magazine
• Do NOT leave the disc magazine in a place
subject to excessive temperature or humidity.
• Do NOT insert more than one disc per slot.
• Do NOT drop the disc magazine.
Reset buttons
The wired remote control and compact disc
changer each have a reset button. The compact
disc changer's reset button is visible when the
disc magazine door is opened. Press either of
the buttons in the following cases:
• All the connections have been completed.
• The unit malfunctions. (For example, if the unit
does not load a CD properly.)
• An error code appears in the display window of
the wired remote control.
When you press this button, use the tip of a ball-
point pen or similar pointed object.
EN
3

Advertisement

loading

This manual is also suitable for:

Adc-rf35Adc-m35