SiPix POCKET PRINTER A6 User Manual page 15

Pocket Printer A6
A6Print prints via infrared and in the future to PDA Serial Cables
Figure 1
Figure 4
Figure 4 ~ More Settings Page
Port - Set the interface from the Palm to the
Printer. Infrared ~or~ Cable
Paper Size: - Set the appropriate paper type.
Sheet Paper ~or~ Roll Paper ~or~ Custom
Unit - Set the unit of measure to be used for
print. Inch ~or~ MM
Orientation - Change the orientation of the
document. Portrait ~or~ Landscape
Custom Paper - For custom fitted paper.
Width ~or~ Length
OK: - This will save settings and close the
"More Settings" / "Print Settings" screen.
Advanced Settings - Go to the Advanced
Settings menu
Cancel - Cancel any changes made to this
screen and return to the Print submenu. (This
does not cancel the print)
SiPix Technical Support
Figure 2
Figure 5
Figure 5 ~ Advanced Settings
Margins: Set Values for all four margins in
inches or mm.
Form Feed Settings:
Normal Form Feed ~ Standard settings
Scroll Feed ~ is a custom setting for the
amount of feed after a print on roll paper. It
adjusts if you wish for more or less room at
the bottom of the print.
Halftone:
None = B/W
Dither 4x4 = 16 shades of gray
Dither 8x8 = 32 shades of Gray
http://www.sipixdigital.com/support/
User's Guide
Figure 3
Start Printing ~ Starts Print
More Settings ~ Defined in Table II
Done ~ Cancels Print Job
Preview ~ Allows you to view document
before printing.
Record Select ~ Defined in Table III
Left ~ Right ~ Top ~ Bottom
Back - Return to the Print Settings Menu
15