Installing The Digital Media Card; Setting Write Protection; Connecting The Flash Drive - SimpleTech NAPSTER Quick Start Manual

I
NSTALLING THE
1 Open the card slot cover. To open the cover,
slide the cover toward the rear of the flash
drive, then lift and rotate it to the open
position.
2 With the label side facing up, slide the media
card into the card slot until you hear a "click"—
indicating that the card is properly seated.
3 Close the card slot cover.
To remove a media card, press the card into the spring loaded card slot. When you hear
a click, release the card, then remove it from the card slot. Close the card slot cover.

Setting Write Protection

The Secure Digital (SD) media card included with the
flash drive has a write protection switch to prevent users
from accidentally erasing the data on the card. To
enable write protection, slide the switch aft to the locked
position. To disable write protection, slide the switch
forward to the unlocked position.
When write protection is enabled, you cannot
format or write data to the digital media card.
C
ONNECTING THE
Remove the protective cap, then plug the flash drive
into the USB connector on your computer.
If you are running Windows 98SE, install the
Windows 98SE driver before connecting flash
drive to your computer.
SimpleTech recommends that you avoid using
the USB port on Macintosh computer keyboards.
This port may not have enough power to
adequately support the USB 2.0 interface.
D M
IGITAL EDIA
F D
LASH RIVE
C
ARD
Card Slot
Cover
Write
Protect
Switch
Digital
Media
Card
Lock
3