Table of Contents
Advertisement
Item
Effect
Button lock
Remocon
User level
ID select
Remote ID
Off
On
Serial ID
Off
On
Item
Effect
Slot Power
V.Installation
Off
On
Rotate
Off
On
Serial Slot
Select
Normalization
When both main unit buttons and remote control are disabled due to the "Button lock", "Remocon User level" or "Remote
ID" adjustments, set all the values "Off" so that all the buttons are enabled again.
Press the
button on main unit together with
The "SHIPPING" menu is displayed and the lock is released when it disappears.
Off
MENU&ENTER
Off:
All the buttons at the bottom of the main unit can be used.
MENU & ENTER:
Locks
and
buttons on bottom face of main unit.
MENU
ENTER/
On:
Locks all the button on bottom face of main unit.
Off
User1
User2
Off:
You can use all of the buttons on the remote control.
User1: You can only use
control.
User2: You can only use
User3: Locks all the buttons on remote control.
Sets panel ID number when panel is used in "Remote ID" or "Serial ID".
Set value range: 0 - 100
(Standard value: 0)
Off:
Disables ID remote control functions. You can use normal remote control operations.
On:
Enable ID remote control functions.
Sets the panel ID Control.
Off:
Disables external control by the ID.
On:
Enables the external control by the ID.
Off
Auto
On
Off:
Power is not transmitted to the slot power.
Auto: Power is transmitted to the slot power only when main power is on.
On:
Power is transmitted to the slot power when main power is on or in the standby state.
Note: In some cases, power is transmitted to the slot power when main power is on or in the
standby state regardless of the slot power setting.
Off:
Sets fan to the horizontal installation mode.
On:
Sets fan to the vertical installation mode.
Notes:
• This functions when display is turned on.
• Vertical installation is available without this mode setting.
• Turn up the power switch for the upward direction when you set Display vertically.
Off:
Does not rotate the image.
On:
Rotates the image 180 degrees.
Slot1
Slot2
Slot3
Selects the slot which communicates serial.
Note: The setting of an external command can be set only from the fi xed serial terminal (see page
10).
button on the remote control and hold for more than 5 seconds.
Options Adjustments
Adjustments
On
User3
,
,
,
,
,
, buttons on the remote control.
Adjustments
Options
Button lock
Remocon User level
ID select
Remote ID
Serial ID
,
,
,
buttons on the remote
Options
Slot power
V. lnstallation
Rotate
Serial Slot Select
2/3
Off
Off
0
Off
Off
3/3
Off
Off
Off
Slot1
43
Advertisement
Table of Contents
