NAD M51 Owner's Manual page 8

IDENTIFICATION OF CONTROLS
REAR PANEL
10 IR IN
• This input is connected to the output of an IR (infrared) repeater
(Xantech or similar) or the IR output of another component to allow
control of the M51 from a remote location.
11 POWER
• Supply the AC mains power to the M51.
• When the POWER switch is set to ON position, the M51 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or remote
control's [ON] button to switch ON the M51 from standby mode.
• If you intend not to use the M51 for long periods of time (such as
when on vacation), switch off the POWER switch.
• With POWER switched off, neither the front panel Standby button
nor remote control's [ON] button can activate the M51.
12 AC MAINS INPUT
• The M51 comes supplied with two separate detachable mains
power cord. Select applicable mains power cord pertinent to your
region's requirement.
• Before connecting the plug to the mains powers source, connect
firmly first the other end to M51's AC Mains input socket.
• Always disconnect the mains power plug from the mains power
source first, before disconnecting the other end from the M51's AC
Mains input socket.
8