Table of Contents
Advertisement
5.
Use the remaining Draw Strings to secure the rest of the Fabric Cover (1) to the
Main Support Frame (3) and Side Frames (2). (See Assy. Diagram.)
6.
Remove the Bolt (11), Flat Washer (7), and Wing Nut (10) from one end of the
Rear Cross Bar (12). (See Figure A and Assy. Diagram.)
7.
With assistance, position the Hunting Shelter against the trunk of a tree. Adjust
the Rear Cross Bar (12) to fit firmly against the tree trunk. Then secure the Hunt-
ing Shelter to the tree trunk by re-installing the Bolt (11), Flat Washer (7), and
Wing Nut (10) on the Rear Cross Bar. (See Figure A and Assy. Diagram.)
8.
NoTE:
Make sure both Bolts (11), Flat Washers (7), and Wing Nuts (10) on the
Rear Cross Bar are firmly tightened.(See Figure A and Assy. Diagram.)
9.
Attach the Side Cover (18) to the Side Frame (2) using the 8 Hooks (17). See
diagram on page 7.
10.
Adjust the height of the shelter so the Side Cover touch the ground.
page photo.
11.
Attach the bottom of the Side Cover (18) to the ground using the U-Shaped land-
scape Staples (19). See Parts List and Assembly Diagram on page 6 and 7.
SKU 96529
For technical questions, please call 1-800-444-3353.
FIGURE A
REAR cRoSS bAR (12)
boLT (11)
FLAT WASHER (7)
WING NUT (10)
See cover
ReV 08e
Page 5
Advertisement
Table of Contents
