Page 1
CAUTION! PLEASE KEEP POWER SWITCH ON BEFORE OPERATING THIS EQUIPMENT Turbo Air Speed up the Pace of Innovation Display Cases Diamond Show Cases Installation and Operation Manual Please read this manual completely before attempting to install or operate this equipment!
CONTENTS PAGE SPECIFICATION GENERAL STRUCTURE AND PARTS HANDLE AND ELECTION PREPARATION AND POWER SUPPLY USE AND CAUTION MAINTENANCE TROUBLE SHOOTING PRINCIPLE OF REFRIGERATION SYSTEM ELECTRIC CIRCUIT DIAGRAM MAJOR PARAMETERS WARRANTY 10-12 SPECIFICATIONS MODEL COMP H.P V/Hz REFRIGERANT AMPS WEIGHT TD-4R 115V/60Hz R-134A 17.2...
Air is sucked air outlet. Let inside in and cold air is circulating cold air circulated inside flow out. the refrigerator. CRT-77-1R and CRT-77-2R are same only except the door. CRT-77-1R has one glass door but CRT-77-2R has two.
HANDLE AND ERECTION Handle with care Dry place Unplug the wall socket first. Always locate the refrigerator at a dry place. Never tilt it over 45 degree during handling. Sufficient space Well environment Keep the rear unit no less than 10cm(4inch) Always locate the refrigerator at a place with from wall or other substance which will Ambient Temperature 16-32ºC / 60.8-89.6ºF.
PREPARATION & POWER SUPPLY Exclusive power socket No share on socket Normally, the power supply should be Never let the refrigerator share the common 110/60Hz single phase AC with exclusive socket with other appliance, otherwise the single phase three pin receptacle. cable becomes hot and fire might be resulted.
USE & CAUTION 1. How to start Plug the refrigerator on 115V exclusive socket. After the refrigerator running, put hand on the air suction to confirm it is sufficient cold. Then put th the cold box. 2. Regulate temperature Normally put the controller at “MID” step. The evapo- rator might be frosted if the controller is at the Step Cabinet Temperature...
MAINTENANCE 1. Notice Often keep the refrigerator clean and periodical maintenance is necessary. Always unplug the socket before maintenance. Never use damaged plug or loose socket to prevent electric shock or short circuit. Never flush the refrigerator. Never use alkali detergent, soap, gasoline, acetone or brush.
PRINCIPLE OF REFRIGERATION SYSTEM The principle of compression refrigeration consists of “Compression”, “Condensa- tion”, “Throttling” and “Vaporization”. The compression is undertaken by compressor, the condensation is completed by condenser, the throttling valve is executed by capillary and the vaporization is implemented by evaporator. When the coolant is circulating in the closed refrigeration system, the compressor sucks coolant, which has absorbs heat in evaporator, the coolant becomes a high pressure and high temperature gas.
MAJOR PARAMETERS Model CRT-77-1R CRT-77-2R Parameter Coolant and injecti on quanti ty R134a (2.927 Ounce) R134a (2.927 Ounce) Rated Input Power (W): Type of cl i mate Ref ri gerati on temperature 0~12℃/32~53.6 0~12℃/32~53.6 El ectri cshock protecti on cl ass Power consumpti on(K W.H/24H)
ONE YEAR WARRANTY Turbo air warrants to the original purchaser of every new Turbo air refrigerated unit, the cabinet and all parts thereof, to be free from defects in material or workmanship, under normal use and service, for a period of one(1) year from the date of original installation or 15 months after shipment date from Turbo air , whichever occurs first.
Page 11
3. ALTERATION, NEGLECT, ABUSE, MISUSE, ACCIDENT, DAMAGE DURING TRANSIT OR INSTALLATION, FIRE, FLOOD, ACTS OF GOD. TURBO AIR is not responsible for the repair or replacement of any parts that Turbo Air determines have been subjected after the date of manufacture to alteration, neglect, abuse, misuse, accident, damage during transit or installation, fire, flood, or an Act of God.
(1) year from the date of original installation or 15 months after shipment date from Turbo Air, whichever occurs first. Any part, covered under this warranty, that are by Turbo Air to have been defective within one (1) year of original installation or fifteen (15) months after shipment date from manufacturer, whichever occurs first, is limited to the repair or replacement, including labor charges, of defective parts or assemblies.