Panasonic NV-MX2 Operating Instructions Manual page 57

2
Reset the Tape Counter to zero at the tape
position from which you want to play it back
l
later.
( 8, 14)
3
Start playback or recording.
4
After playback or recording has finished:
Slide the [OFF/ON/MODE] Switch to set the
Movie Camera to VCR Mode.
≥The [VCR] Lamp lights up.
5
Rewind the tape.
≥The tape automatically stops approximately at the
position where the counter was set to zero.
Stopping editing automatically during audio dubbing
1
Set [DISPLAY SETUP] >> [C.DISPLAY] >>
[MEMORY].
2
Reset the Tape Counter to zero at the position
where you want to stop editing.
3
Play back the still picture where you want to
start audio dubbing.
4
Start audio dubbing.
≥Audio dubbing automatically stops at the position
where the counter was set to zero.
l
( 32)
57