Samsung SNB-2312 KIT User Manual

Identification of features
(+) Terminal
Positive (+)
(-) Terminal
Terminal
Charge Indicator
Negative (-)
- Red Light: charging in process
Terminal
- Green Light: charging completed
- Yellow Light: discharging in process
Charge
Indicator
- Red Light Flickering: charging error
[ Battery Charger & Battery ]
Using the Battery Charger
With the AC cord
1. Insert the AC cord into the charger. 2. Plug the AC cord's power plug into the wall
outlet.
Notice
When power is supplied to the charger, the charge indicator will illuminate for 1 second.
(Orange Color)
6
How to charge the Ni-MH Battery (SNB-2312)
3. Place the (-) and (+) terminals of the battery in the correct
position. Press the (+) terminal to set the battery correctly
as shown in the figure.
The red Charge indicator indicates normal charging. When
charging is complete, the indicator turns green.
Notice
If the charge indicator illuminates as green when you insert the battery, your battery is
already charged to full capacity and cannot be charged any longer.
If the charge indicator blinks as red, it indicates a battery charging error.
- If the battery is not properly inserted
- If the 2 terminals (+, -) are dirty or damaged
If the battery is inserted properly and the charge indicator continues to blink, contact the
nearest Samsung Camera Service Center.
The battery charger (SBC-N1) has a discharge function.
Ni-MH cells have a memory effect. For long battery life, it is best to fully charge or
discharge the battery. When batteries are charged in the battery charger (SBC-N1), the
charger first discharges residual capacity and then starts charging. If the Charge indicator
shows yellow when the battery is put in the charger, it means that the charger is
discharging the battery. In this case, the process may take from several minutes to about
two hours, depending on the residual capacity of the battery.
After the completion of discharge, the Charge indicator turns red and charging starts.
It may take about four hours to charge a battery, based on 2300mAh.
If the temperature of charger exceeds 65 C, charging is stopped and the lamp to check
charging flashes. In this case, charge the battery again after the temperature of charger is
dropped.
Warning
The charger (SBC-N1) is dedicated for Samsung Ni-MH cells only.
Charging Ni-Cadmium cells or low capacity Ni-MH cells may generate severe heat in the
battery. We recommend using Ni-MH cells with a capacity of over 2000mAh.
Memo
7
SAMSUNG CAMERA
User Manual
Digimax Power Pack
SNB-2312 KIT
ENGLISH
Thank you for purchasing the Samsung Digimax Power Pack. This manual contains important
safety and operating instructions for your power pack. Be sure to read and understand the
instructions before using your power pack.
Specifications
Cell Type Ni-MH Cell x 2
Ni-MH battery Cell Capacity 2,300mAh
(SNB-2312 ) Voltage 1.2V
Charging Time Approximately 240 Minutes
Input AC 100-250V/ 50-60Hz
Battery Charger
Output Ni-MH Cell : 1.5V 0.6A
(SBC-N1)
Rechargeable Battery Type Ni-MH battery (SNB-2312)
Specifications are subject to change without prior notice.
Safety Instructions
Be sure to read this manual carefully before using your power pack.
Keep this manual handy for future reference.
6806-2264