Advertisement
Quick Links
Advertisement
Summary of Contents for POLTI FA 110
- Page 1 Dryer FA 110...
-
Page 3: Technical Details
5 - Air inlet 6 - Hole for direct condensation drainage 7 - Top air outlet 8 - Power cord winder Polti S.p.A. reserves the right to change equipment 9 - Power cord or accessory specification without prior notice. CONTROL PLATE DESCRIPTION... - Page 4 When the tank is full, the appliance stops operating and the water level indicator (TANK FULL) lights up. DRYER FA 110 is also equipped with an automatic defrost device. When the room temperature is lower than 12°C, the device automatically starts operating for 8 minutes every hour.
- Page 5 • Do not insert sharp objects through the air inlet screen. • Never immerse the appliance in water or any other liquid. • DRYER FA 110 is able to operate properly in places where temperature is included between 5 and 35°C. Outside this range, the protection device of the compressor will stop the operation of the appliance.
- Page 6 ENGLISH • When the DRYER FA 110 is in operation, the compressor will produce heat and the room temperature could become slightly higher. This condition is quite normal. • Close all the doors and windows when the appliance is in operation to obtain better dehumidifying results.
- Page 7 “defrost” function for 8 minutes every hour. During this functioning mode the “DEFROST” indicator light comes on. • DRYER FA 110 is equipped with a water level indicator: when the water storage level becomes full, the compressor and the fan stop and the red indicator light “TANK FULL”...
- Page 8 ENGLISH Fig. 3 • Take out the water tank by pulling it outwards. • With a tool remove the cover of the hole for direct condensation drainage, which is at the back of the unit (fig. 3). • Insert a PVC water drainage pipe of 14 mm I.D. in the drainage hole and connect it to the drainage mouth at the front of the unit (fig.
- Page 9 ENGLISH • In case of failure or malfunction, do not attempt to disassemble the appliance but contact your Polti Service Centre. PROBLEM CAUSE REMEDY The appliance does The appliance is not Connect the appliance to not function connected to the mains...