WARNINGS It is most important that this instruction book should be retained with the appliance for future refer- ence. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
scrape off frost or ice. Frost may be removed by • Parts which heat up should not be exposed. using a plastic scraper. Under no circumstances Wherever possible the back of the product should solid ice be forced off the liner. Solid ice should be against a wall.
Cleaning the interior Freezing fresh food Before using the appliance for the first time, wash The 4-star compartment is suitable for the interior and all internal accessories with luke- long term storage of commercially frozen food, and warm water and some neutral soap so as to remove for freezing fresh food.
Shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during trans- portation. To remove them proceed as follows: Move the shelf retainers in the direction of the arrow, raise the shelf from the rear and push it for- ward until it is freed and remove the retainers.
• water ices, if consumed immediately after from the foodstore to the freezer in the shortest removal from the freezer compartment, can pos- possible time; sibly cause the skin to be freeze burnt; • not open the door frequently or leave it open •...
Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a spe- cial container at the back of the appliance, over the motor compressor, where it evaporates.
INSTALLATION Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. For safety reasons, minimum ventilation must be as shown in Fig. Appliance positioned under overhanging kitchen wall units (see Fig. A). Appliance positioned without overhanging kitchen wall units (see Fig.
Door reversibility 1. Unplug the appliance from the power supply before carrying out the below-mentioned opera- tions. 2. Remove the ventilation grill (D). 3. remove the hole cover (G) and the bottom hinge (E). 4. Remove the freezer door by releasing it from the middle hinge (H).
Page 10
Marynen Huishoudelijke Apparaten Postbus 120 2400 AC Alphen aan den Rijn Telefoon: (0172) 468 330 Telefax: (0172) 468 215...
Need help?
Do you have a question about the CM 2826 DT and is the answer not in the manual?
Questions and answers