Specifications - Panasonic DMP-BDT110EG Operating Instructions Manual

Specifications

Signal system:
Operating temperature range:
Operating humidity range:
10 % to 80 % RH (no condensation)
Video output:
Audio output:
Number of connectors :
Digital audio output:
Optical digital output (Optical terminal)
HDMI AV output: Type A (19 pin) [BDT310] : 2 system
[BDT210] [BDT111] [BDT110] : 1 system
This unit supports "HDAVI Control 5" function.
SD card slot:
USB slot:
Ethernet: 10BASE-T/100BASE-TX : 1 system
WLAN [BDT310] [BDT210]
Antenna:
Standard Compliance:
IEEE802.11n / IEEE802.11a / IEEE802.11g /
IEEE802.11b
Transmission system:
MISO-OFDM system, OFDM system, DSSS
system
Frequency range:
IEEE802.11n / IEEE802.11a :
IEEE802.11g / IEEE802.11b / IEEE802.11n :
Transfer rate (standard)*:
IEEE802.11n:
IEEE802.11g / IEEE802.11a:
IEEE802.11b:
Access Mode:
Security:
(This unit supports WPA and WPA2 encryption.)
LASER Specification
Class 1 LASER Product:
Wave length: 790 nm (CDs)/655 nm (DVDs)/405 nm (BDs)
Laser power:No hazardous radiation is emitted with the
Power supply:
Power consumption:
[BDT210] [BDT111] [BDT110] : Approx. 11 W
Power consumption in standby mode:
Power consumption in quick start standby mode:
[BDT210] [BDT111] [BDT110] : Approx. 3.3 W
Dimensions (WkDkH)
Mass:
Specifications are subject to change without notice.
* Transfer rates are theoretical values; however, actual
communication rate will vary according to communication
environment or connected equipment.
12
(12) VQT3B62
PAL/NTSC
i5 oC to i35 oC
1.0 Vp-p (75 ≠)/Pin jack:1 system
2 Vrms (1 kHz, 0 dB)/Pin jack
2 channel:1 system
Connector : 1 system
USB2.0 : 2 system
Tx 1, Rx 2
5.15 GHz to 5.35 GHz
5.47 GHz to 5.725 GHz
2.4 GHz to 2.4835 GHz
Tx Max. 150 Mbps,
Rx Max. 300 Mbps
Max. 54 Mbps
Max. 11 Mbps
Infrastructure mode
WPA2-PSK (TKIP/AES)
WPA-PSK (TKIP/AES)
WEP (64 bit / 128 bit)
safety protection
AC 220 to 240 V, 50 Hz
[BDT310] : Approx. 13 W
Approx. 0.2 W
[BDT310] : Approx. 4.3 W
Including the projecting parts:
430 mmk185 mmk35 mm
Approx. 1.6 kg
Information for Users on Collection and Disposal of
Old Equipment and used Batteries
These symbols on the products,
packaging, and/or accompanying
documents mean that used electrical and
electronic products and batteries should
not be mixed with general household
waste.
For proper treatment, recovery and
recycling of old products and used
batteries, please take them to applicable
collection points, in accordance with your
national legislation and the Directives
2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly,
you will help to save valuable resources and prevent any
potential negative effects on human health and the
environment which could otherwise arise from
inappropriate waste handling.
For more information about collection and recycling of
old products and batteries, please contact your local
municipality, your waste disposal service or the point of
sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this
waste, in accordance with national legislation.
For business users in the European
Union
If you wish to discard electrical and
electronic equipment, please contact your
dealer or supplier for further information.
[Information on Disposal in other
Countries outside the European Union]
These symbols are only valid in the
European Union. If you wish to discard these items,
please contact your local authorities or dealer and ask for
the correct method of disposal.
Note for the battery symbol (bottom
two symbol examples):
This symbol might be used in combination
with a chemical symbol. In this case it
complies with the requirement set by the
Cd
Directive for the chemical involved.
To dispose or transfer this unit
The unit may keep the user settings information in the unit.
If you discard this unit either by disposal or transfer, then
follow the procedure to return all the settings to the factory
presets to delete the user settings.
≥ The operation history may be recorded in the memory of
this unit.