Registering The Handset To The Base Unit - Panasonic KX-TGA731E Installation Manual

TGA731E(e).fm Page 4 Thursday, February 14, 2008 11:48 AM
1
Firmly press the notch on the handset cover and slide it in the direction
of the arrow.
2
Insert the batteries negative (T) end first. Close the handset cover.
3
Place the handset on the charger for about 7 hours before initial use.
Note:
L The handset display may show "Please Wait..." when the
handset is placed on the charger if it is not registered to the base unit.
L If the batteries are fully charged, but the operating time seems to be
shorter, clean the battery ends (S, T) and the charge contacts with a
dry cloth and charge again.

Registering the handset to the base unit

Ensure that the handset is switched on. If it is not on, press and hold
{ih} for few seconds to turn the handset on.
1
Handset:
Lift the handset and press {ih}.
2
Base unit:
Proceed with the operation for your model.
N KX-TG7301
Press and hold {x} for about 5 seconds. (No registration tone)
N KX-TG7321
Press and hold {x} for about 5 seconds, until the registration tone
sounds.
L If all registered handsets start ringing, press the same button to
stop. Then repeat this step.
4 Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333