Safety And Important Notice - Philips BDP2180 User Manual

Cannot access BD-Live features.
Make sure that this player is connected to
Make sure that the network installation is
Make sure that the Blu-ray disc supports
BD-Live features.
Network
Wireless network is not found or distorted.
Make sure that the network is correctly
Make sure that the network installation is
Make sure that the wireless network is
not disturbed by microwave ovens, DECT
phones, or other neighboring Wi-Fi devices.
If the wireless network does not work
properly, try a wired network installation
Browse PC works slowly.
Look in your wireless router's user manual
for information on indoor range, transfer
rate, and other factors of signal quality.
You need a high speed Internet connection
for your router.
3D videos
Cannot see 3D effects
Make sure that 3D output is turned on(see
Make sure that the disc title being played is
Blu-ray 3D compliant.
Make sure that the TV is 3D and HDMI
compliant, and the TV is set to 3D mode
(refer to the TV's user manual).
Make sure that the 3D glasses are activated
(refer to the TV's user manual).
7 Safety and
important
notice
Read and understand all instructions before you
use this Blu-ray disc/ DVD player. If damage is
caused by failure to follow the instructions, the
warranty does not apply.
Important notes for users in
the U.K.
Mains fuse
This information applies only to products with a
UK mains plug.
plug. If you replace the fuse, use one with:
the ratings shown on the plug,
a BS 1362 approval, and
the ASTA approval mark.
Contact your dealer if you are not sure about
what type of fuse to use.
Caution: To conform with the EMC directive
(2004/108/EC), do not detach the plug from
the power cord.
How to connect a plug
The wires in the power cord are colored as
follows: blue = neutral (N), brown = live (L).
If the colors do not correspond with the colors
on your plug, identify the terminals in your plug
as follows:
1
Connect the blue wire to the terminal
marked N or colored black.
2
Connect the brown wire to the terminal
marked L or colored red.
3
Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
colored green (or green and yellow).
Before you replace the plug cover, make sure
that the cord grip is clamped over the sheath
EN
21