Related Manuals for Philips HTD3200
Summary of Contents for Philips HTD3200
- Page 1 Always there to help you Register your product and get support at www.philips.com/welcome HTD3200 Question? Contact Philips User manual...
-
Page 3: Table Of Contents
Contents 8 Troubleshooting 1 Important Safety Care for your product 9 Notice Care of the environment Copyright Compliance 2 Your home theater Mains fuse (UK only) Trademarks Main unit Remote control 3 Connect and setup Speakers Connectors Connect to TV Connect audio from TV and other devices 4 Use your home theater... -
Page 4: Important
1 Important wall mount. Koninklijke Philips Electronics N.V. bears no responsibility for improper wall mounting that results in accident, injury or damage. Read and understand all instructions before you • For speakers with stands, use only the use your home theater. If damage is caused by supplied stands. -
Page 5: Care For Your Product
of children at all times! If swallowed, the battery can cause serious injury or death. Severe internal burns can occur within two hours of ingestion. When this crossed-out wheeled bin symbol is • If you suspect that a battery has been attached to a product it means that the product swallowed or placed inside any part of the is covered by the European Directive 2002/96/... -
Page 6: Your Home Theater
2 Your home theater Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your home theater at www.philips.com/welcome. Main unit a Disc compartment b Display panel (Open/Close) Open or close the disc compartment, or eject the disc. - Page 7 Open or close the disc compartment, or • In radio mode, set a radio station. eject the disc. n REPEAT A-B c Source buttons Mark two points within a chapter or track DISC: Switch to disc source.Access • to repeat play, or turn off the repeat mode. or exit the disc menu when you play o CREATE MP3/ZOOM a disc.
- Page 8 • (Standby-On): Press and hold to switch your home theater, TV and the connected devices to standby. • (Play/Pause): When a video disc is in the disc compartment, wake up the TV from standby, and then play a disc.
-
Page 9: Connect And Setup
3 Connect and setup This section helps you connect your home theater to a TV and other devices, and then set it up. For information about the basic connections of your home theater and accessories, see the quick start guide. Note •... -
Page 10: Connectors
Connect to an analog audio output on the Connectors TV or an analog device. g ANTENNA FM 75 Connect other devices to your home theater. Signal input from an antenna, cable or satellite. Front Connect to TV Connect your home theater to a TV to watch videos. -
Page 11: Composite Video
On your TV, turn on HDMI-CEC. For automatically played on the home details, see the TV user manual. theater. » When you play a disc on your home To play audio from TV programs through theater, the video is automatically your home theater, connect an additional displayed on TV and the audio is audio cable (see 'Connect audio from TV... -
Page 12: Connect Audio From Tv And Other Devices
On your TV, switch to the correct video Option 2: Connect audio through input. analog audio cables To play audio from TV programs through Basic quality audio your home theater, connect an additional Using an analog cable, connect the AUX audio cable (see 'Connect audio from TV connectors on your home theater to the and other devices' on page 12). -
Page 13: Use Your Home Theater
4 Use your home Select SURR repeatedly to select a surround mode. theater • DOLBY VS: Creates a highly compelling 5.1 channel listening experience. STEREO: Two-channel stereo sound. • This section helps you use the home theater to Ideal for listening to music. play media from a wide range of sources. -
Page 14: Usb Storage Devices
Select [MP3/JPEG Display], and then press Button Action Navigation Flip the picture vertically or Select the following options, then press buttons horizontally. (up/down) [View Folders]: Display the MP3 • SUBTITLE Select subtitle language for video. folders. DISC Access or exit the disc menu. [View Files]: Display the MP3 files. -
Page 15: Divx
Play files Note • Make sure that the subtitle file has the same name as Connect the USB storage device to the the video file. For example, if the video file is named home theater. 'movie.avi', save the subtitle file as 'movie.srt' or 'movie. Press USB. -
Page 16: Audio, Video, And Picture Options
[Disc Time]: Skip to a specific part of • Audio, video, and picture the video by entering the disc time (for options VCD/SVCD only). [Track Time]: Skip to a specific part of • the video by entering the track time Use advanced features when you play audio, (for VCD/SVCD only). -
Page 17: Radio
PROGRAM Manual: Radio 1) Press OPTIONS. 2) Press to select your preset. 3) Listen to FM radio on your home theater, and OPTIONS again to Press store up to 40 radio stations. store the radio station. What you need Automatic: Press and hold for •... -
Page 18: Easylink
Create MP3 files EasyLink Use your home theater to convert audio CDs The home theater supports Philips EasyLink, into MP3 files. which uses the HDMI-CEC (Consumer What you need Electronics Control) protocol. EasyLink- • An audio disc. compliant devices that are connected through •... - Page 19 One-touch standby When you press and hold (Standby) on the remote control, the home theater and all the connected HDMI-CEC devices (that support one-touch standby) switch to the standby mode. If one-touch standby is enabled on your home theater, you can switch to standby with the remote control of the TV or other HDMI- CEC devices.
-
Page 20: Change Settings
5 Change settings Picture resolution To enjoy high definition HDMI video output, set the HDMI video settings that best match up This section helps you to change the settings of with your TV capability. your home theater. SETUP. Press Select [Video Setup], and then press OK. Caution Select [HDMI Setup], and then press OK. -
Page 21: Parental Control
Select a menu language for discs, and then Home menu press OK. SETUP. Press Note Select [General Setup], and then press • If your preferred disc language is not available, select Select [OSD Language], and then press [Others] from the list, and enter the 4-digit language code found at the end of this user manual. -
Page 22: Energy Saving
Enter the password with the Numeric Sleep timer buttons. Set timers to switch the home theater to Select an age rating, and then press OK. standby after a specified time. • To play all discs irrespective of the rating, select level 8. SETUP. -
Page 23: Apply Factory Settings
Apply factory settings Reset your home theater to the default settings. You cannot reset the parental control settings. Press SETUP. Select [Preference Setup], and then press Select [Default], and then press OK. Select [Ok], and then press OK. -
Page 24: Update Software
USB flash drive or CD-R. Step 1: Download the latest software Connect a USB flash drive or insert a CD-R to your computer. In your web browser, go to www.philips. com/support. At the Philips Support website, find your product and locate the Software and... -
Page 25: Product Specifications
7 Product File formats specifications • Audio: .mp3, .wma • Video: .avi, .divx, .mpg, .mpeg, • Picture: .jpg, .jpeg Amplifier Note • Total output power: 300W RMS (10% • Specifications and design are subject to change without THD) notice. • Frequency response: 20 Hz-20 kHz / ±3 •... -
Page 26: Remote Control Batteries
Laser • Compatibility: Hi-Speed USB (2.0) • Type: Semiconductor laser GaAIAs (CD) • Class support: USB Mass Storage Class • Wave length: 645 - 665 nm (DVD), 770 - (MSC) 800 nm (CD) • File system: FAT16, FAT32 • Output power: 6 mW (DVD), 7 mW •... -
Page 27: Troubleshooting
If you still have a problem, get support at www. TV are connected through an HDMI ARC philips.com/support. connection. • Set up the audio for the connected device... - Page 28 The operation is not possible. EasyLink does not work. • Make sure that the home theater is connected to a Philips brand EasyLink TV, and the EasyLink option is on (see 'EasyLink' on page 18). When you switch on the TV, the home theater automatically switches on.
-
Page 29: Notice
9 Notice Contact your dealer if you are not sure about what type of fuse to use. Caution: To conform with the EMC directive (2004/108/EC), do not detach the plug from This section contains the legal and trademark the power cord. notices. - Page 30 10 Index audio options control buttons DivX lock/unlock menu language options amplifier picture audio play HDMI audio subtitle predefined modes synchronize picture and sound quality time search settings titles specifications display audio input mapping MP3/JPEG menu audio language VCD/SVCD menu audio options display panel auto standby...
- Page 31 HDMI password Philips Easylink audio video settings picture HDMI-CEC high resolution JPEG settings slideshows troubleshooting language picture options audio play disc menu discs onscreen menu subtitle radio slideshows troubleshooting main unit position overview connectors specifications position troubleshooting preference media formats...
- Page 32 system audio control safety disposal use of the product time search screen saver titles settings trademarks troubleshooting audio auto standby connection default main unit disc language picture HDMI audio play HDMI video sound HDMI-CEC menu language parental rating update software password picture check current version...
- Page 33 Language Code Inupiaq 7375 Pushto 8083 Abkhazian 6566 Afar 6565 Irish 7165 Russian 8285 Afrikaans 6570 Íslenska 7383 Quechua 8185 Amharic 6577 Italiano 7384 Raeto-Romance 8277 Arabic 6582 Ivrit 7269 Romanian 8279 Armenian 7289 Japanese 7465 Rundi 8278 Assamese 6583 Javanese 7486 Samoan...
- Page 34 Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N.V. All rights reserved. HTD3200_12_UM_V1.0...