Panasonic TX-P42VT30Y Operating Instructions Manual page 33

Disposal
A lithium-ion polymer rechargeable battery is built in to the 3D Eyewear. Please discard according to local regulations.
When disposing this 3D Eyewear, disassemble properly by following the procedure below, and remove the internal
rechargeable battery.
Do not disassemble this 3D Eyewear except when disposing of it.
Danger
As the rechargeable battery is specifically for this 3D Eyewear, do not use it for any other device.
•
Do not charge the removed battery.
•
Do not throw the battery in a fire, or apply heat to it.
•
Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it.
•
Do not let the wires touch any other metal or each other.
•
Do not carry or store the battery with a necklace, hair pin, or the like.
•
Do not charge, use, or leave the battery in a hot location such as near a fire or under the hot sun.
Doing so may cause the battery to generate heat, ignite, or rupture.
Warning
Do not place the removed battery, screws, and other items within reach of infants.
Accidental swallowing of such an item may have an adverse effect on the body.
•
In the event that you think such an item has been swallowed, consult a doctor immediately.
In the event of fluid leaking from the battery, take the following measure, and do not touch the fluid with bare hands.
Fluid entering into an eye may cause loss of eyesight.
•
Wash the eye with water immediately without rubbing it, and then consult a doctor.
Fluid getting on your body or clothes may cause inflammation of the skin or injury.
•
Sufficiently rinse with clean water, and then consult a doctor.
■
How to remove the battery
Disassemble this 3D Eyewear after the battery has run out of power.
The following figures are intended to explain how to dispose of the 3D Eyewear, not for describing how to repair.
The 3D Eyewear cannot be repaired once it has been disassembled.
1
Fold the part of the
frame without the power
switch, and then remove
the two screws on the
inside of the hinge with a
precision Phillips (plus + )
screwdriver.
3 Remove the battery from
inside the side cover, and
cut the two wires one by
one with scissors.
•
Insulate the wire parts
of the removed battery
with cellophane tape.
Note
•
Take sufficient care when performing this work so as not to injure yourself.
•
Do not damage or dismantle the battery.
2
Bend the frame inwards
and pull it off from the
side cover.
•
Frame
If it is difficult to
remove, insert a
flat-blade (minus - )
screwdriver and force
Screws
it off.
Side cover
Battery
33