Table of Contents
Advertisement
Quick Start Guide
Connect the mains plug to the wall sock et.
1
Press the [
] switch on the TV set to turn the
set on.
To switch the TV set to Standby mode, press the
button on the remote control.
The TV set can be switched on by pressing the
button again if it was in Stand by mode.
Note:
This TV will still consume some power even in
the Off mode, as long as the mains plug is still
connected to a live mains socket.
C.A.T.S. sensor
LCD C.A.T.S. (Contrast Automatic Tracking System) automatically
senses the ambient light conditions and adjusts the brightness and
gradation accordingly, to optimize contrast.
C.A.T.S. is in effect when Viewing mode is set to Auto. See page 11.
2
Programmes will appear immediately if your dealer has programmed
the TV for you.
If the TV has not been programmed for you then Auto setup will
begin.
The TV will search for Analogue stations:
TV stations will be located, sorted into order and stored ready for
use.
Analogue stations are sorted into channel order, but can be changed to your preference. See page 15.
The sorted programme order depends upon the TV signal, the broadcasting system, and reception
conditions.
3
TV to VCR or DVD Recorder Download
If a "Q-Link", "NEXTVIEWLINK" or compatible recording device has been
connected to a Scart terminal (AV2 or AV4) before starting Step 1, programme
information will be downloaded to that device.
The programme positions will be downloaded to the recording device, in the same order as stored in the TV.
See page 21.
Not all VCRs / DVD Recorders support this download of programme information, some may require to be
started manually.
Refer to the recording device's operating instruction book.
If a recording device other than those described above has been connected, then there will be no download
operation.
Notes:
• If the recording device has not accepted download data from the TV, you may need to select the Download
option from the device's menu system. Refer to the recording device's operating instruction book.
• If Q-Link is not operating correctly, check the following:
The Scart cable is connected to the TV's Scart terminal, AV2 or AV4, and correctly setup in the menu.
The Scart cable is connected to the recording device's compatible (Q-Link, NEXTVIEWLINK or similar
technology) Scart terminal.
The Scart cable is a "fully wired" type.
• For further information on Q-Link and connecting equipment, see page 21, 29, 32.
PULL
Power Indicator
Standby : Red
On : No Light
Remote control signal sensor
CH12
AUTO SETUP IN PROGRESS
SEARCHING :
PLEASE WAIT
01
99:21
Exit
DOWNLOAD IN PROGRESS
PLEASE WAIT
Programme : 63
Remote control unavailable
OK
1
2
3
4
5
6
7
8
9
C
0
N
TV
41
7
Advertisement
Table of Contents
