Quick Start Guide; Connection Of Receiver To Tuner Terminal Board - Panasonic TU-PT600B Operating Instructions Manual

Quick start Guide

1. Connection of Receiver to TUNER Terminal Board

( 1 ) T h i s R e c e i v e r i s o n l y f o r P a n a s o n i c P l a s m a D i s p l a y w i t h a T U N E R Te r m i n a l B o a r d .
(TY-42TM5H, TY-37TM5H)
(2) And the TUNER Terminal Board (TY-42TM5H, TY-37TM5H) is compatible only with the products given below
and those that will be sold hereafter.
(TH-50PHW5B, TH-42PHW5B, TH-42PW5B, TH-37PW5B)
(3) When DISPLAY OUT of this set and TUNER IN of a plasma Display are connected, an input select can not be
performed in a Plasma Display. Please perform an input select by this set.
The PC IN terminal and SERIAL terminal on the back of a Plasma Display cannot be used.
The INPUT select, Volume Up '+' and Down '-' of the front of a Plasma Display do not operate.
Power-Indicator
Antenna Input terminal
(see page 9, 10, 11)
AV1 Scart socket (In/Out)
TUNER Terminal Board
(TY-42TM5H / TY-37TM5H)
Note:
Install the Receiver at least 15.7 inch (40 cm) away from the Wide Plasma Display to avoid interference.
Be sure the power to the Wide Plasma Display and Receiver is OFF before connecting cables.
8
AV3 input terminals
Video Camera Cable terminal
AV2 Scart socket (In/Out)
AV4 Scart socket (In/Out)
AV1 AV2
RGB VIDEO
S-VIDEO
VIDEO
+
VOL
—
INPUT
/ BY
POWE R R - STAND ON
G POWER
AV3
S-V V L R
AV4C COMPONENT Input
P P
AV4 R
R
RGB VIDEO
AUDIO
S-VIDEO
TUNER IN
Back view of Wide Plasma Display
Audio Output
Y L
B
DISPLAY OUT
R
VIDEO
L
AV4C
AUDIO OUT
AUDIO
PC IN SERIAL
Display out
terminal